• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Polo62's latest activity

  • P
    Polo62 reacted to Dave6T4's post in the thread Engine width with
    Like
    .
    The difference can be seen where the distributor clamp butts up against a boss on the 400 block, versus a pad on the taller and wider...
  • P
    Polo62 replied to the thread Engine width.
    Thanks trying to figure if my c body hp manifold would clear on drivers side in a b body 70 charger
  • P
    Polo62 reacted to Curiousyellow71's post in the thread Engine width with
    Like
    .
    Deck height on a 440 10.725, 400 9.98. Difference of .745" blueprinted. When I measured with a tape the 440 is slightly less then 3/4"...
  • P
    Polo62 posted the thread Engine width in Engine, Trans & Driveline.
    How much wider is a 440 than a 400 from drivers side exhaust ports to passenger side exhaust ports thanks for any reply
  • P
    Polo62 replied to the thread Engine i.d..
    Thanks everyone
  • P
    Polo62 posted the thread Engine i.d. in Engine, Trans & Driveline.
    Can someone tell me the year of this engine and what body style it came from thanks for any info I already know its a 440
    • 20240524_140447.jpg
    • 20240524_173718.jpg
  • P
    Polo62 reacted to Aron Gleason's post in the thread Torque converter with
    Like
    .
    Yes. Make sure the converter is either internally balanced or you'll need the correct flex plate.
  • P
    Polo62 replied to the thread Oil pressure.
    Thanks man I just wanted to know before I put it in my charger done put a 400 in it that runs crappie bad valves or cam wanted this one...
  • P
    Polo62 reacted to dadsbee's post in the thread Oil pressure with
    Like
    .
    Lucky to have 15 psi on the 440 in my Bird. Have run the **** out of it for 34 years.... zero issues.
  • P
    Polo62 replied to the thread Torque converter.
    Thanks everyone mine is going dead when put in gear and running like crap at idle speeds
  • P
    Polo62 reacted to Darter6's post in the thread Torque converter with
    Like
    .
    Had the stater go bad in one. Car wouldn't idle in gear and stall. I should say shut off when dropping it into gear. BUT it was a...
  • P
    Polo62 reacted to Curiousyellow71's post in the thread Torque converter with
    Like
    .
    Worse case is they Balloon shoving the crank ahead screwing up the thrust bearing, crank and block. More typical in a High hp higher...
  • P
    Polo62 replied to the thread Oil pressure.
    The motor is inshop hanging on a chain hoist you can't rev it much wants to turn over maybe 2000 rpm and it didn't get over 35psi and...
  • P
    Polo62 reacted to eldubb440's post in the thread Oil pressure with
    Like
    .
    30-35 is ok....... does it increase at all with RPMs....... thicker oil might give it a bump
  • P
    Polo62 posted the thread Torque converter in Engine, Trans & Driveline.
    Will a torque converter out of a 727 with 318 out of a 78 d100 truck fit a 727 in a 70 charger with a 440
Show older items
Back
Top