Search results for query: *

No rust, sevicable parts seem good, struts could use new rubber bushings. I believe that the k-member is for a big block, has Schumacher mounts for a Gen ll Hemi. $500. OBO. Not shipping, but can deliver to Stillwater swap meet in Minnesota.

Do not know where I read this, but said that solid state IVR's can cause lazy gauge movement. I had a missing pin in a circuit board, and installed the new IVR with the new circuit board. Fuel gauge was always lazy, so I installed my old IVR. VIOLA, fuel gauge moves fast and to me normal...

Pulling my hair out over rocker arms for my 426 Hemi. I just haven't found the right place. Stock rockers, need to have the tips resurfaced, bushings are alright in my opinion. Would or can go to a roller rockers, but that is more of a can of worms than where I am at. Street car...

Was setting up yesterday to eyebrow the top of my cyls for the Edelbrock Jr intake valves. With a a Felpro #1104 gasket and the head on with 3 bolts , I have roughly .050 between the intake and the cyl. That's looking in from the bottom with the piston out. Am I missing something? Why do...

Delete, have answer.

I bought a Hemi clone Road Runner last year and I have the engine apart. Have just changed the rods, rebalance and had the block hot tanked. I noticed that the oil passages to the cylinder head have been tapped and have restrictors in. This engine has stock valve train, should I remove the...

I am looking for the wire end holder for the two reverse light wires. This picture shows the two wires plugged into the bulkhead connector half of the smaller or male plastic holder. I am looking for the other half.

Has anyone purchased carpet from Stock Interiors? How did they do? Product okay? Ship like they say? Sounds like they do their own work.

Looking for a '69 Road Runner/Satellite glovebox switch/light and attached harness. Light bulb end of mine is gone.

Has anyone one ever tried to freshen up the faded orange needles on the Amp, fuel, temp, and speedo ? Haven't gotten in there yet, I can live with them the way they are, didn't want to send them out to have everything reconditioned and calibrated. If someone has done this, what paint did...

What color is the switch lettering on a '69 Road Runner? Silver or white?

Why will this switch panel not come out? It's loose, but will not come out. All wiring is out, 4 screws are out. Can not pull the pad until the switches are out. What am I missing? This isn't repopped to my knowledge and I don't want to destroy it.

Just got a positive battery cable for a '69 Hemi 4-speed. This was a race car and I am moving the battery from the trunk back to the engine bay. I haven't cut the plastic package open, but looking inside, it appears to have a connector for the reverse switch at the trans? I already...

Looking for the rear sill plates, they cover the carpet, attach to the door sill plate by one screw. Not sure if they may have a groove for the rear side panel, below the window. Need both sides. '69 Plymouth Road Runner

My recently purchased Hemi clone '69 Road Runner has a Champion 26" radiator, won't really accept a fan shroud, stock one anyway. Actually, the radiator doesn't fit well either. Anyone using a Cold Case with a stock fan shroud? Changing from a fixed fan to clutch drive fan. I have the...

Has anyone purchased new bucket seat tracks? Would like to know if they are a thumbs up or down. I would rather pay the price of new versus the used price, and what it takes to recondition them. '69 Road Runner.

Has anyone dealt with PG Classic? I need a set of bucket seat tracks. Any issues dealing with them? Would like any feedback before ordering.

Has anyone ever drilled the stop rivet out in the seat track of a bucket seat and pulled the mechanism apart? I am the proud owner of a really messed up pair of bucket seats. Track to floor mounting studs are gone, wire for seat adj is gone, and the tracks really need some attention. I...

'69 Road Runner, driver floor vent. I see no call out for it in DMT site. The seal between the housing and cowl is in kits, or heater rebuild kits, but doesn't really mention the foam for the vent door. Is it in the heater kit? I called them today, the gal that answers the phone didn't...

Can someone tell me on a '69 Road Runner, I have a hole above the ignition switch, anyone know about this light? Least I figure it's for a light. Must be a metal casing twist in bulb? Go through a relay somewhere, probably a momentary light just for key into ignition? I have looked...