Search results for query: *

Can someone please tell me where these go? Picture would be great.

Can someone tell me the correct name for the access holes on the fender well just behind the alternator is called?

1968 Plymouth GTX - Does anyone know what was used to attach the fiber/rubber boots on the openings in the engine compartment located on the fender wells? Also were these access ports, cooling and what was the correct name.

Can someone please tell me what numbers in the VIN on the data plate would indicate that the car is an original Hemi? Also does the engine have matching serial numbers to the VIN, if so where are they located on the engine? Last did Plymouth leave any Hemi blocks with "blank" serial numbers on...

Has anyone installed Hooker 5903-1HKR on a 1969 B Body? I have yet to get a set of headers that willl clear the steering box, just wondering if these will. Thanks for any advice.

Ok, working on my winter projects and the driver's side door window has always been difficult to roll up or down. So, I pulled the regulator out and the window is still so stiff in the tracks it will remain in whatever position I put it. Is this normal? Do the tracks have adjustments to...

Can someone with the knowledge of, or someone who would be so kind to take a picture of the brake pedal assembly mount (w/automatic transmission) which shows how the spring is supposed to be attached. Spring is about 3 inches long. There appears to be a notch in one of the attaching bolts but...

Can some one tell me if there is any difference in a 1969 Dodge Coronet 440 valve cover and a 1969 Plymouth Cuda valve cover? Thanks.

OK, I give up. I have paid to have this done twice, to two different individuals to set up this new rear end. Same results both times. Sounds like marbles rolling around in a barrell during deceleration. Really is it that difficult???! Any help would be appreciated.

During high forward speeds my lift off hood is getting me worried. The very front actually rolls up and I am concerned that it might even crack or break. Is this normal, or is there a way to reinforce it to prevent this from happening?

Rebuilt the steering box on a 1966 Sport Fury. Reinstalled filled with fluid and when cranked the steering goes all the way left and locks. Anyone got any ideas?

Does anyone know how to adjust the cable linkage for the above car? 727 transmission but the cable needs adjusting somehow.

Does anyone know how to wire the stock Fury reverberator? A diagram would be great.

Can someone tell me how the weaterstrip molding is attached to the truck of a 65 Sport Fury with the trunk light switch on the left corner. Ordered two and neither seem to fit??

Anyone know if the windshield cowling can be removed from a 1969 b body? If so, how?

The left front tire began squealing during a left turn. Although I did a cursory check, front end, ball joints etc are all relatively new. Nothing obvious. I checked the wheel bearing, re-greased and adjusted. Made no difference. Secondly I had the car aligned, which it was out. Squealing...

My 440 six pack loses fuel prime overnight. Takes 30 to 40 seconds grinding the starter to pick the fuel back up. Starts all day fine afterward. But overnite same thing again. Anyone got any ideas.

My 440 six pack loses fuel prime overnight. Takes 30 to 40 seconds grinding the starter to pick the fuel back up. Starts all day fine afterward. But overnite same thing again. Anyone got any ideas.

Just installed new backs/seat covers and the seat back will still not stay up (always been that way the screw on the left bottom appears to have nothing to hold to. Anyone have any experience with this and/or solutions?

Anyone know? Is it possible to remove the hydraulic lifter from a 69 440 without pulling the intake. Use a lifter removal tool?