Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hey guys, I’m looking for an original Dodge Direct Connection license plate. I see that places sell them new but they look like they are flat instead of stamped like the originals. This is the plate that says Dodge across the plate and in small font at the bottom says Direct Connection. White...
I'm not there but our shop is set up inside. We brought a blue '46 Ford Woodie that we just finished up for a customer. Our shop is Precision Hot Rods & Fabrication
Yes, I hit the area where the seal sits and it brought the dutchman down in the middle. The welding seemed to put slightly more radius across the Dutchman side to side so hitting it flattened it out to match the crown of the front of the trunk lid.
I had the same exact problem on my '68, however my Dutchman was the original and I had a new AMD trunk lid. I had my Dutchman panel off when I did new quarters. When I reinstalled the Dutchman I clamped it right over my spot weld holes so it was in the same exact spot. The center of my original...
We have uniforms for the shop that I work at. Monday through Friday I'm in them from when I wake up and get dressed for work and take them off at night before I hop in the shower. If we're going somewhere in the evenings then I'll throw a T shirt and jeans on. Even on the weekends if I'm going...
If your AMD torsion bar cross member is anything like the one I bought then yea, it's short. I bought an AMD piece and when I saw how short it was I sent it back and found a nice original and it dropped right in. Also, the slugs that the torsion bars slide into were on different angles than the...
The older versions are prone to leaking. I bought a set of the older versions despite being warned for my '68 440 and they didn't make it through the dyno break in without leaking oil. I ended up buying a nice original set from Tony's Parts and using my AMDs for wall hangers. Supposedly they...
Made a fixture to hang my K member on the engine stand. I used some old square tubing, a piece of 10ga steel and some new hardware. I'm going to make one for the rear end housing too. I had both acid dipped so it'll be nice to spin them around and work on them.