Search results for query: *

Selling trim and clips for Automatic Console 66 - 70 B Body. Good to very good shape. Not totally sure what they are worth, but one piece sold for $50 so thinking $100 or reasonable offer plus shipping.

Selling trim and clips for Automatic Console 66 - 70 B Body. Good to very good shape. Not totally sure what they are worth, but one piece sold for $50 so thinking $100 or reasonable offer plus shipping.

Thanks guys for the information. It's supposed to warm up next week so I will try reversing the lines and see if it leaks when it's warm outside. I think I may also try an anti-surge vented gas cap ( i posed the question to the Stant website and their response was that it should solve the...

The only thing that has changed was adding the short vent tube (at the front of the tank). Initially no vents were connected, they replaced the tank and left them capped. This caused a pretty bad vacuum any time you drove it. Last year only had the long vent (one that goes up into the trunk)...

Filled the car for the winter and got an oil change, when parked at home (pretty flat, just the rake to the front from suspension) noticed a gas smell, a large puddle forming from the short (J) vent near the tank. I have seen numerous threads on this issue. It was a warm day, but not hot. My...

Had the dash out to deal with some connection/electrical issues and when we reinstalled we had to disconnect the cable from the transmission to pull the speedo wire back to get the clip to install in the dash. The speedo cable was replaced not too long ago and worked fine before we removed the...

Thanks for the input. Took the alternator in to have it looked at. Rectifier was burnt out when the output stud shorted. They replaced rectifier and tested. Alternator tested fine. Installed tonight and now have 14.5 at the Voltmeter and between 13.75 and 14.10 at the battery with no fluctuation...

Thanks guys... Took a closer look. When I pulled the terminals off the post and got a good look at it the plastic washer was melted onto the nut so I could not tighten the post at all it's also brown and discolored around the nut. This cant be good :) Think I'll have to pull the alternator and...

Got back at it again tonight. When I reconnected the battery and tried to start it it was dead. Charged it and the readings are the same at the battery. One thing I did notice is that the post on the alternator was hot (would burn your finger) after I shut it off, that's likely a symptom of load...

Had not had my car running for a while and have done a lot of work around the electrical system. Cleaning connections, adding grounds, cleaned bulkhead connections, changed out cluster and added a voltmeter. Just got it running again and noticed that the Voltmeter will run between approx 14...

No worries, the measurements you had in your post were helpful in giving me the measurements I needed to get risers built for the A body seats and tracks I had in the car.

Well, spent about 6 hours at it yesterday. Starter relay had a bit of corrosion on connectors, cleaned it up and it started. Not sure if that was the problem as it has just as mysteriously started working again before. But hey fingers crossed. While we were at it had by buddy put some tension...

Hey Guys.... Thanks for all the great info. I thew a charger on the battery and will get at it later today. There is no click, no nothing, totally dead. It's a 1969, with a fair bit of work done on various parts, but not much under the dash. No MSD, it has a Mopar electronic distributor and...

I have an intermittent electrical issue. The car can be running fine one minute, turn the key off and go to start again... and nothing (no click, no headlights, aftermarket tach needle will move a bit). It actually happened to the mechanic when I had it in for some work. They tried to trace and...

Pretty old post. Not sure if you have answer or even still have them. They are 68-69 B Body tracks as you indicated from a 68 Charger. If you still have them and don't need/want them are you interested in selling? If so you can PM me.

Does anyone have the dimensions of the tracks/risers? At a minimum the height (of the two different sizes) front and back (the more measurements the better) . Thanks!

That's us... our rural roots and that help your neighbor or whoever needs help mentality. In this day and age it's pretty refreshing and something we are proud of. Thanks for your kind comments!

Finally tracked down some seat info from the guy I bought my car from. The seats are buckets out of a 1971 Demon (A body). These seats mount to the floor not through it. As a result they don't have the risers I see on 1969 Plymouth seat tracks so they sit way too low in the car and will not...

Hello from the Saskatchewan Canada, Always been a Mopar fan owned a few as did many friends. Now wish that we had kept a few of them. Decided that I needed a retirement project and after looking for quite a while found this numbers matching 69 Plymouth Sport Satellite (383, 4 speed) that fit...