Search results for query: *

I’m making a fresh ad for my carb. Also listed it on E body forum. This is a new factory remanufactured Holley in the box. List 4376 date is either 3029 or 3629 second digit is a lite stamp. Production line center six pack carb for the 1970 model year. 900 and shipping included in the lower 48...

302 day of 69, the middle digit is hard to read if it not 302 it is 362 either way late December 1969, production line 1970 model year.

there is a lemon twist 70 cuda with some gran coupe options on bring a trailer right now. auction will be ending soon

Getting my 67 GTX painted. Original dark blue poly. That formula is not available with the major paint lines. We tried a 70 color b9 which is available in Omni but the spray out is a very dark blue, the flop under sunlight shows a more discernible blue metallic but not loving the spray out...

rt parts? no

I have an old RT grill that has been hanging as wall art. It is a long way from pristine. Repairs are viewable from the back side. 25 plus shipping

Holley assembly line set of six pack carbs. 4391 center manual trans, 4393 and 4394 outboards. All carbs are within 30 days of each other. I went through them replacing gaskets, accelerator pump diaphragm etc. Both secondary diaphragms hold vacuum. You can likely use these as is or send out for...

This is a square back alternator, the rear casting shows a 1973 build, the front is not discernible. Boxed and tagged as part number 7509. Looks like it was rebuilt on 10/19/2000. Never installed. 100 plus shipping.

These were powder coated in R4 red pretty close match. Project never happened looking to move these along. 125.00 plus shipping. 8M date for those would like a specific date .

yes turn signal/directional

I need this one, 4 th picture down

directional switch is bad

Bump dropping price to 1000.00

preferably I’d like a known good oe Mopar 3:23 gear set for a 742 case, coarse spline pinion. I attached a picture of ring gear that has a Mopar part number on it. It had three chipped teeth. This gear set uses the pinion that is straight, does not use a crush collar instead it uses shims to set...

i would check with hobby/arts and craft stores like Hobby Lobby etc

honestly i don't know, everything stock so it didn't dawn on me to check for something like that

pulled the driveshaft and both u joints are perfectly smooth in their operation. Tail shaft bushing looks good too.

I had that issue once picked the car up with a floor jack on the pumpkin, had a buddy inside holding the clutch pedal down, started it in gear and dropped the lift quick the shock freed it up

sent a pm

I’ll do that tomorrow