1969 Road Runner

[mmartoi]

I have 69 road runner, I am putting in a Qa1 suspension front and rear. I am also installing a Hellcat with Hp90 transmission.
Ford 9 325 rear-end.
Question being,
Does anyone know where you can get a engine and transmission stand that I can mount the k member on and then engine and transmission to use a 4 post lift to install from bottom?

Does anyone know what crossmember worked for you? I have installed a level 3 Stiffening Kit under the car for strength.

 

[pnora]

67-75 Mopar A Body Frame Connectors

 

[mmartoi]

I have already installed these but for a b body. I am wanting to know what transmission cross members is everyone using when going with after market suspension

 

[pnora]

I have already installed these but for a b body. I am wanting to know what transmission cross members is everyone using when going with after market suspension

The link I posted has cross members under b-body. You could also discuss that with them.

 

[gkent]

I think US Car Tool sells the stand you want. They're simple to build - if you have the tools and equipment.

 

[Project66]

I did a TKX swap on my '66 Satellite a couple of years ago. Everything seemed to go in fine, but I need a little more space to get my driveline angles just right, so I cut the crossmember and installed this set-up from Holley.

https://www.holley.com/products/engine_swap_parts/hemi_swap_systems/parts/BHS532
https://www.holley.com/products/engine_swap_parts/hemi_swap_systems/parts/BHS539

The arch is beefy and should be plenty strong. I used an air hammer to gain the extra clearance for it, but it went in fine following the instructions and using the supplied hardware. I have not driven the car with this setup, but I am sure it will work fine.