WTB 440 Crank Drilled for 4spd

[PurpleBeeper]

I'm looking for a forged 440 crank drilled for a 4 speed (pilot hole in back). I think a 413/426 crank would work too since I plan to balance the motor. I'm now in the St.Louis area and could drive to meet you as far as maybe 250 miles. What do you have?

 

[5.7 hemi]

Stupid question but it’s gotta be asked, forged or cast!

 

[PurpleBeeper]

Stupid question but it’s gotta be asked, forged or cast!

I'm looking for a drilled forged 440 crank. I "thought" that only forged crank motors got 4-speeds and even when they went to cast crank motors (74 or 75?), if it had a 4 spd it still got a forged crank, but I could be wrong on that.

 

[5.7 hemi]

I think I have cast crank, I’ll need to look and see if it’s drilled.

 

[moparsteve636]

I'm looking for a forged 440 crank drilled for a 4 speed (pilot hole in back). I think a 413/426 crank would work too since I plan to balance the motor. I'm now in the St.Louis area and could drive to meet you as far as maybe 250 miles. What do you have?

I've got a couple! Get back to me if you're still in town! I'm 20 min. no of St. Louis

 

[5.7 hemi]

That will save some money right there!

 

[Mark B]

I'm looking for a drilled forged 440 crank. I "thought" that only forged crank motors got 4-speeds and even when they went to cast crank motors (74 or 75?), if it had a 4 spd it still got a forged crank, but I could be wrong on that.

I am pretty sure your right on the mark. I have a factory stock never apart 78 Ramcharger it has a 400 and a 4 speed and it has a forged crank.

 

[PurpleBeeper]

I've got a couple! Get back to me if you're still in town! I'm 20 min. no of St. Louis

Thanks Steve, I will send you a pm with my phone number.

Whoops! your inbox is full (so was mine). I just cleared my inbox, so please send me a pm and we'll go from there. I'm taking the wife out to dinner tonight (to butter her up about building another motor), but I will get back to you at least by tomorrow. Thanks