Correct u-joint for 29 spline yoke

[DWinTX]

I just installed a new rear end in my 65 Coronet. I have upgraded from a 2.94 open to a 3.55 Sure-Grip with new parts from Dr Diff. I went to put the driveshaft in and found that on the new yoke, which is a 29 spline, the saddles for the u-joint are farther apart that the original 10 spline yoke.

I don't care if I have to get a new u-joint, but will that fit my driveshaft? I asked Cass to give me a list of everything I would need for this swap (he sold me the new yoke) but he didn't mention that my original driveshaft wouldn't work.

 

[68GTX4SPEED]

You can use a conversion joint, http://www.ebay.com/itm/New-Moog-72...ash=item43ede5be0c:g:OosAAOSw1-RUam1c&vxp=mtr

 

[DWinTX]

Awesome!. Thanks very much.

 

[Cranky]

There are actually 4 different yokes....course and fine, wide and narrow for both. I have a 29 spline small u-joint yoke if you rather do that but the conversion joint will work too.

 

[DWinTX]

Thanks for the offer Cranky, but I've already got everything together all that's left is the driveshaft. I'm anxious to get rolling. I found one of the conversion joints locally, so tomorrow I hope to be on the road and try the new gears (with my new engine and new transmission).