Stripper or media blasting

[bearman]

I can see that media blasting would be best but cost to much for my budget. So I have been stripping panels as I go but leave small patches of old paint in areas such as the corners of the trunk lid etc. I have done the strip thing a couple of times. So will the exopy primer and sealer take care of this and not have problems later or do I just keep digging at until it's all gone. Thanks bearman

 

[69L48Z27]

Once it’s under epoxy it should be fine. Just dig out as much as you can. Post a pic of what you have left.

 

[bearman]

Will post this week. Have other projects finishing up so I can get back to it. Thanks on the input

 

[4406bbl]

I would never leave anything that has had stripper put on it and shoot epoxy over it, asking for problems, sand it with 80 grit on a da if stripper don't work.

 

[gkent]

Get a small spot blaster from Harbor Freight and blast those small areas.