Recent content by Daytona Jim

I need a pair of high & low tone horns for my 69 Charger (may be the same as used on other B bodies, don't know). Need to be in good working condition. Thanks

1969 Dodge Charger 4 speed. Also need a good pair of high and low tone horns for the same car. Thanks, Jim in Napa

The clutch and brake pedal housing under the dash is supported by three rods. I need the shortest rod and bolts. Thanks for any help.

I have a pair of exhaust manifolds that came with my project 69 Charger. The right side casting number is 2780518 with a casting date of 2/10/66. The manifold is not drilled for choke tube. The left side casting number is 2780611 with a casting date not readable. My cars build date is...

Need for my 69 Charger but also used in other b body Dodge models. I need the carpet hold down trim that extends from the door sill plats to the rear door panel. Thanks

Need 1/2" hemi oil pickup. Mopar original , used is fine. Thanks.

Yes Sir. Sounds good to me. I'll contact you.

Need a hemi intake heatshield. New preferred but good used one will work. Thanks

Looking for L&R hemi motor mount brackets. I have the insulator portion of the mounts, just need the brackets. Thanks for any help.

I'm looking for 1 426 Hemi rocker stand. I need the non oiler type stand. Thanks for any help.

Yes, The 69 Charger with a 4 speed and Dana.

Thanks all. I'm going with 50.96 inch's.

PM sent.

I can't find a driveshaft for my 69 Charger 4 speed/dana 60. I am working with Doctor Diff to make me a driveshaft. He is asking for the universal joint center to center measurement length. I don't have my four speed transmission installed in the car yet, so can't give him the measurement he...

Found them. Thanks to everyone.