fontleyroy's latest activity
-
fontleyroy replied to the thread TKX 70 Charger.The drivers header really beat me up today. I must have had that on and off ten times. That little dimple turned into a big dimple. I... -
-
fontleyroy replied to the thread TKX 70 Charger.Heres a pic of the new headers and the spot I have to dimple.
-
-
fontleyroy replied to the thread TKX 70 Charger.Finally a day above freezing! I decided to wait until the deep freeze was over to get back in the garage. Was able to cut out the...
-
-
fontleyroy replied to the thread TKX 70 Charger.Forgot to add , if you have headers you must put the starter in position ready to bolt to the bellhousing before you install the...
-
fontleyroy replied to the thread TKX 70 Charger.Wound up cutting the tunnel a little to far in the back but still beats that monster hole that SST wants you to cut. And of course I...
-
-
fontleyroy replied to the thread TKX 70 Charger.Was not able to put the time in the garage as I had anticipated. The holidays were hectic. Child home from college, brother up from...
-
-
fontleyroy replied to the thread TKX 70 Charger.You are welcome. If you have not read Kerndogs post on his swap I highly suggest you do. He and Coronetdarter have documented the...
-
fontleyroy replied to the thread TKX 70 Charger.And the bellhousing mounted to the trans afterwards.
-
-
fontleyroy replied to the thread TKX 70 Charger.Here a picture of the bellhousing with the section I had to take some off circled in red.
-
-
fontleyroy replied to the thread TKX 70 Charger.Its easier to mount the bellhousing to the trans on the bench to install the hydraulic bearing and the line and the plate. The...
-
-
fontleyroy replied to the thread TKX 70 Charger.Another couple hours in garage today. Installed the clutch and the hydraulic bearing and the bellhousing. Had to take some metal off...
-
-
fontleyroy replied to the thread TKX 70 Charger.Two hours today to put the clutch in. Remove bellhousing after runout measurement. Clean/degrease flywheel, clean/degrease clutch...
-
