Recent content by mopardemon

Looking for a machine shop in southern Ontario I'm in Toronto. There's ones that i know of but there 4.5 hours west of me or 4 hours east of me. Don't mind driving a bit. and please don't tell me Beaty and Woods. thanks Jim

well looks like final decision is made spoke to Dwayne and finalized the cam selection, going with something that will be a bit more pleasing for the street. 245/249 at 50 112 lsa 640/640 lift I think I will be very happy with that

i guess ill have to try and see, if not will have to go aftermarket hood

I have a 70 gtx 440 does anyone know or have a victor intake with tfs 240 heads installed in a 70rr or gtx, just trying to figure out if they will have clearance for the hood and air grabber when the hood is closed. thank you

spoke to Dwayne this afternoon had a great conversation, spoke on a few different topics, the knowledge he has is beyond, gave me a few recommendations, in the end i told him i would leave it up to him on the choices he gave me. going to keep this under 6000rpm

thanks for the reply, I'll give them a call

Looking for a hydraulic roller cam, my set up is trick flow 240, max valve lift 680 victor intake Quik fuels Q950 carb Harland sharp 1.6 roller rockers stroker kit from 440 source 4.350 bore 4.250 stroke compression is 10.6-1 comps recommendation was custom Grinde at 50 int 252 ext 262 lift...

im sorry will do next time and thank you all

Hello all restoring my 70 gtx brake booster and master cylinder was missing when i bought the car, i have disk on the front and drums on the rear, all help would be appreciated Thank you

now that's what I'm talking about, I would be happy with that

Im willing to live with a 505 and that hp and torque, I have spoken to guys there, they wanted close to $8000us for an aluminum block, cant seem to find an aftermarket cast block

Thanks for the wake up call andyf, your correct I don't need 750 hp for the street/strip and it is a pump gas motor I'm looking to do, I might of gotten ahead of myself, any suggestions on what to use would be appreciated. what I have, a set of trickflow 240 and 270, victor intake and a holley...

not sure cant find the email

looking for a compression of 10.5-1, Im not a pro at this, looking for all the info and help I can get, the victor intake has been ported to match the heads as for the rotating assembly its not purchased yet, what I have so far is block, intake, heads and carb, I also have a set of 240 trickflow...

will look into the lifters