Recent content by paul1969cars

Hi Anyone know what size drum was stock on 1969 roadrunner 11x2.5? sound correct? Thanks

Hi all Maybe Im doing something wrong I installed my 4spd trans in with throw out bearing on Im trying to get clutch fork on but I cant slide it behind the throw out bearing and into the clips. The throw out bearing is already up against the clutch Am I supposed to back out tranny now and...

Hi What color is the couple and shaft from couple up towards the firewall I have seen them black or natural metal. The books say could be either. Dont know whats right

Thanks I know the pump and pulley above are black. Wasn’t sure about lower steering box attached to the k Member Thanks

Hi Just wanted to know if the stock steering box is a natural metal finished or was it painted black from factory. Thanks

Hi Can someone tell me how many leaf's make up the leaf spring assembly on both sides of the car My roadrunner (8.3/4 rear) has aftermarket leaf springs. Im changing out the lower leaf with an originally stamp leaf with part number 2539213 Are both sides the same with the amount of total...

Hi Im restoring the rear end of 1969 8.75 rear. while Im doing this, I need to change out the seals since there is evidence of liquid loss. Any one know any good seal kits to purchase? Also Im attaching a few photos of rear. The passenger side of rear doesn't have a retainer clip holding...

nice

holley numbers are on front of carb. top right side

I think I may just cut out lowest pan area becuase its only bad in lower grooved area that way I keep factory welds I will clean it up and see Thanks

Yes I think that is best. Unless you can put a rachet strap around a one piece and curl up sides to fit through the caro area. I know people have said that is doable but Im not sure

Yes thanks I see that.. Not doing that. I will go with two piece

Hi The car was painted by previous owner and its in great shape. They just didn't do the trunk pan. So Im not removing and painted panels. just need to change out the floor pan. I assume I need to do it in halfs

I’m going to swap out trunk floor in road runner. It’s got some pin holes and typical rust in the recessed grooves I’m not changing the trunk extension or quarters Can I put in a one piece floor through trunk. Or do I have to order it in halves?? Thanks all

Hi just want to verify the part number for the stock leaf springs I think its 2539-214 for 1969 383 roadrunner convertible also anyone know where I can get just the lower leaf spring with that number? other than junk yards. I know Vans sells only dana rear leafs