Recent content by stat5

1967 Only heater control face plate for non AC equipped cars, fits Belvedere, Gtx and Satellite. $50 plus shipping Stillwater, MN

68-70 Vent/Wing window bracket in good condition. I believe this if for the RH side. $60 plus shipping Stillwater, MN

Here is one on the ebag. https://www.ebay.com/itm/126740854094?

2002 Matco tool calendar. $10 plus shipping This calendar will have to be shipped in a 20" tube. Stillwater, MN

1967 and 1968 Steering wheel horn ring, the ring may fit 1969 model years as well. The ring has pitting, in my opinion driver quality at best. $15 plus shipping Stillwater, MN

1967 Only heater control face plate for non AC equipped cars, fits Belvedere, Gtx and Satellite. $20 plus shipping Stillwater, MN

Interior rear window 4-piece chrome set for 1966 and 1967 2-door hardtop Coronet, Satellite, Belvedere and GTX. Chrome is driver quality in my opinion. One of the top pieces of chrome has a area where chrome is gone, see pictures. $85 plus shipping. Location Stillwater, MN

Looking for a core 22" radiator part number 2785960 fits 383-2. Thanks

I PM you

I'm looking for a original bolt and nut used to mount the spare tire stud to the trunk floor. Thank you for looking.

I'm looking for a clean 1966 or 1967 non AC heater control unit that fits Belvedere, Satellite or GTX. I don't need the face plate just the assembly. Thanks

These screws came with my basket case 1967 Belvedere that I picked up and I can't figure out where these screws are used or even if they were used. Any help would be appreciated in identifying where there were used, I attached a picture of the head and side view of the screws. Thank for any...

What does a original 1967 Dana 60 brass brake tee block look like that is held on by the axle vent? A picture would be great Thank you for any replys.

What do the screws look like that are used on the interior trim around the sides and top of the rear window on 2dr hardtop (GTX, RT, Coronets, Belvedere and Satellites)? Pictures would be great. Thank for any replys.

Thank you for the input and pictures it was most informative, the car I'm working on putting back together is a 67 Plymouth 2-dr hardtop. My roof rails had remnants of the foam on them, based upon picture I found the correct screws.