Search results for query: *

Thanks for your input. Can you post a pic of the charger you have? Thanks.

My 35 year old Shauer battery charger and boost starter finally stopped working. Asking for recommendations from others here. I am not looking for a battery tender or maintainer. Looking for a battery charger with a meter and jump start capability. Thanks.

I would replace them. Way past their lifespan. BFG's do not do well when they are old like that. I just had one blow out on me a couple of months ago. I was on a road and just got underway when the traffic light turned green. Maybe only doing 20 mph and I feel the left front of my 68...

I have done the Vinegar and water treatment. Works very well. Just de rusted 2 brake drums with vinegar and water.

Also something to keep in mind; exhaust systems can sound differently depending on if you're using manifold vacuum or spark ported vacuum.

If you're looking for a stock exhaust system. Accurate Exhaust sells the full set up. They also sell a dual exhaust system for those that want to go from single to duals.

I used Slip Plate graphite spray lube as someone here already mentioned. Never had a clogging issue. Before I use any spray paint , I sit the can in some warm water for about 10 minutes. This atomizes the paint. Spray comes out really good. I always turn the can upside down when I am done...

I agree with backing down your initial timing. I would even back it down to 5 degrees BTDC, see if you have pinging; if no pinging, keep going up on your initial till you hear the pinging. Someone mentioned earlier you might need to use different advance springs in the distributer.

That Omni is a good product. Been using it for a few years. Very happy with the results. To add their 2K primer is very good.

Would be worth the trip to get.

The best way to do thiis is to mock it up with the front and rear glass sitting in their places. You need to see how the glass sits so that you can adjust the positioning of the roof skin to the glass. Even getting the measurements you need may not be accurate. You could end up with a...

Round 2 will be releasing an all new MPC 68 Coronet convertible with the Haul-It trailer this month. Here is the Round 2 January release video on Youtube. Fast forward to 12:40 Also, here is the announcement from the Round 2's FB page.

Yes' I have had paint supply stores use the camera to come up with a match. Depending on the color I can be very accurate, metallic colors are usually around an 85 percent match. Camera matching for example, white is nearly a 100 percent match. It's a numerical grading. 1 being the best and...

Are you looking for just the curved piece? If so, just that part is not reproduced. Just get the trunk gutter section pictured and just use what you need. Keep the rest just in case you have to repair other areas. I hope I answered your question.

I've done it a few times.

How bright are the dash lights on you 67 GTX after doing the headlight relay kit modification? The same or brighter? Did the modification eliminate the issue of the dash lights dimming when coming to a stop and then brighter when accelerating?

Most definetly. I would use phosphoric acid with 1/3rd water mixed, brush on the area. Then, cover with saran wrap so the phosphoric doesn't evaporate but stays wet dissolving the corrosion. Maybe a day or two covered is all it takes for the rust to go away. Just check under the surface...

I took mine out. They were easy to get to and remove. I did this with the glass in. I would first slip an exacto knife blade behind the staple, push the staple out a tad,then with a flat headed screwdriver push the rest of the way out. The original staples where a copper type coating...

I agree. Trunk lids are going for crazy money. I've seen rusty 68 Coronet trunk lids go for hundreds of dollars.

Condolences and prayers sent and your family.