Search results for query: *

Keeping the charger original ,my question is my 318 is bored 30 over and I believe a tow cam. Was going to slap a 4 barrel intake on but now was thinking just putting a 2 barrel 500 cfm holley instead. Will have duel exhaust on it. Whats your thoughts on this? I believe I will have to get a...

1970 charger 318,should I get the one with the vent/return line ? Hoping when the car is done stroking the 318. Yes something different but trying to say 1 step ahead. thanks Dave

1970 charger 318 been sitting for 16 years. So got it running and original carb I had to pump it at low rpm would not idle. Bought new carb same thing. Plugged all vacs on intake and still will not idle . Starts no problem and higher RPM does not miss. Points distributor new cap rotor and wires...

So Ive been working on the charger and was able to get it to bark, sprayed starting fluid in carb. So I moved to the pump since the tank was hosed. Ran a line to bucket and line to gallon jug to see if it would pump and to blow out any gunk. Nothing,turned the engine over 7 times still nothing...

the vapor return line is the nipple on the sending unit or tank? thanks dave

Is the sending unit the one that gets the vapor fuel line return? thanks Dave https://www.autometaldirect.com/amd-gas-tank-sending-unit-38-outlet-w-return-line-68-70-dodge-plymouth-b-body-p-4068.html

440 6 pack with N96 setup. No I dont have the vapor return line It was an 383 car. Will it help until I do install an vapor return line? 1/4 thick https://www.ebay.com/itm/Holley-Heat-Insulator-Base-Flange-Gasket-For-Model-2300-Carbs-/292562711327

looking to sell my ramcharger 4 barrel air cleaner,how do I know if it is original ? It does have the drain tubes on the base. Thanks Dave

How do you remove the lead plugs at the base of the outer carbs on the 6 pack setup? would 1/2 turn out be the base to start at? thanks.

looking for pic from fuel pump to top fuel line. was there a fuel filter between the 2 lower lines? thanks Dave

so why is there two different air cleaners for the air grabber-tops?

So I have had the 6 pak with vacuum secoundary setup. I liked it and it responded good. No complaints at all. Now I bought this Bee and in the purchase was a 6 pak setup with mechanical outboards. Not installed yet. 1 of my friends says the mechanical setup has a better response. So which setup...

bought the car and pan was replaced and vapor line is jacked. need some close up pics for holes. These holes are wrong. 1st pic passenger side trunk I think the hole gos on other side of circle. 2nd pic under car. Does both vent lines on tank get hooked up? any pic please