Search results for query: *

I’m looking for a water pump pulley for my 66 Valiant that I’m putting air conditioning on. It’s an early AC style with the large drive pulley that’s rubber damped. I noticed that my 68 Coronet 318 has the exact same pulley system as the 66. Does anybody have a water pump pulley that is 4 1/2”...

Anyone have the two cage nuts and special washer/machine screws to hold the console down in a 1966 Charger? Seems like in ‘66 the consoles used this unique method before going to a bracket were a sheet metal screw is just used.

have misplaced the wide spring clip that secures the vacuum hose block to the AC switch for the Valiant. They are all the same.. anyone have one they would part with?

Long shot for FBBO but need a 360 oil pan for an early A Body... Jim

Anyone have an early SB timing cover (believe Poly will work). The one that does not have the timing indicator on the driver side. Looking for a nice one with minimal pitting in the aluminum. Thanks Jim

Looking for the crank pulley for a small block AC car. They are a bit special as they have dampers built into them. There were 2 part numbers and I am not sure what the difference is as they are both 3 groove (diameter?)... 2536752 is the part number for AC and no PS 2402730 is the part...

Looking for some front OEM drums for my Coronet.

Does anyone have a factory Master Cylinder for late 60's B Body? Back when they were the 4 piston calipers. Here is what they look like. Very unique cover shape, like a pyramid. Jim

Anyone have a good driver quality RH Rocker moulding for a 68 Coronet they are willing to part with? If you don't know which side you have the rounded corner goes to the front of the car and should be on the bottom side toward the ground. Mine has the LH one on the RH side and probably a...

1968 and probably 69 Coronet. If you open the hood and look down in front of the radiator support on each side the outer headlight and marker light harness goes though a hole in the inner fender to make its way to the backside of the outer fender. That pass through has special body plugs that...

i am also looking for a 68 Coronet 318 with AC AirCleaner. Rather have an old grubby one as I plan to hack out then bottom and graft in a 5 1/8" hole for my FITech EFI. I think the AC version has a small dent in the front to clear the compressor.

Anyone have a OEM Exhaust hanger and bolts for a 68' B-Body (Coronet). Jim

Anyone have a 318 laying around that they would be willing to part with the throttle bracket that is connected the rear left intake manifold bolts. Also would like the spring that goes between the carburetor and the kick down bracket, that pulls the kick down rod back on the carburetor pin...

I am looking for a few special bolts for the '68 Coronet 318. 1) Anyone have these J-Bolts for the air intake on the right side of the plenum. They hold the duct to the plenum. 2) 318 AC compressor. Anyone have an old 318 with an RV-2 compressor that would part with one of the nuts and...