Search results for query: *

I posted an earlier thread about a 3/16" gap between the flex plate and converter with the converter fully seated in the tranny, was told it was fine. When I try to bolt the flex plate up to the converter the converter will not pull in against the flex plate. I am bending the flex plate. I...

Installing my 727 to a new used 440 I bought from a friend. New flex plate from 440 Source. New torque converter from Frank at Dynamic Converter. When I mated the tranny to the block there is a 3/16" gap between the flex plate and torque converter. My new ARP bolts only have 1/2" of thread. How...

PRW Performance Platinum Series?? Never heard of them. Has anyone used this flex plate? PRW Industries 1844010 Performance Quotient PQx Platinum Series High-Integrity Flexplates | Summit Racing

I'm currently having my transmission gone through while I wait for my new engine. I will need to replace the TC since the new engine has a steel crank versus the old cast crank engine. I have narrowed it down to a 2400 stall after way too much reading on this subject. My three choices that I...

Been having a problem with my 440 since it was built. I pulled it this weekend and just removed the timing cover. According to a video I watched on youtube, Pete's Garage-Cam install it shows the timing dot on the cam gear at 6 O'clock, pointing straight down towards the gear on the crank...

I want to check the angles on the driveshaft and rear end to make sure everything is with in tolerance. The 1969 FSM shows how to do this but they are using an old fashion bubble level. When I built my 68 Charger several years ago I had found the process on how to check it and the angles were in...