• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Search results for query: *

  1. NZ 70 RR

    altered Gearbox crossmember

    Finally got around to swiping 4 speeds in the RR. had to trim 10mm off input shaft as crank pilot hole not deep enough (must be an auto crank drilled after leaving factory). Put a pilot bearing in. Old 4 speed got an overhaul and it is going in my Cuda project as it had the correct shifter...
  3. NZ 70 RR

    Input shaft on 4 speed too long

    Took old 4 speed out and tried for hours to get replacement one in, was always 25mm ( 1") gap between housing and 4 speed casing. Finally took it out and used a ruler only to find the input shaft was 25mm longer on replacement one. Looks like the gearbox that came out has had its shaft...
  4. NZ 70 RR

    Z bar washer

    Have I got this setup correct ? Is this bracket/plate in the correct place.
  5. NZ 70 RR

    Clean a Carby

    My Carter carby is real dirty, what is the best way to get it clean and tidy ? Carby clean and small brush ? Thoughts please. Thanks, Tony
  6. NZ 70 RR

    Thrust bearing

    I do not know anything about 4 speeds but this thrust bearing does not look good. Should the sharp edge be sticking up on the inside of the bearing face ? Buy a new one ? where is the best place to buy from ?
Back
Top