Search results for query: *

I'll look for it. Which Mecum auction did you attend with the car?

Watch this youtube video presented by Todd's Restorations. He shows you how to remove the dash bezel with the instruments. I have done this a few times and its gets easrier each time. Very helpful video. Also in the Service Manual, page 8-84 - Instrument Cluster removal instructions. Good luck

I am a AACA member and this is my first trip to Hershey. I have owned many different cars over my lifetime and have enjoyed AACA events. However I understand that this event is a Demonic says, "Every guy should see it". I have a short list of items that I need and will be on the lookout for my...

Just curious if anyone is going to Hershey next week. I am going for the first time and am looking forward to it.

Fortunately i have a lift, so I will partially disassemble today and drop enough so I can bend the ears. Thanks to all who commented.

I agree I should have done that before I installed. I compared to my original tank and I saw the difference in the angle. I agree with you, Rather than wait and see what happens, I think I will try to bend the ears up and away from the exhaust tailpipe.

Last week I installed a new gas tank in my 1967 charger. This morning I installed the tailpipes onto my exhaust system. Both tailpipes are just touching the triangular flap that is on each side of the gas tank. I assume that that should not be the case. I thought I would post a few pictures and...

I found this exact part at Steele Rubber and bought it. Thank you

I am looking to buy an OEM filler neck grommet #2203472. I have a 67 Charger and I replaced the filler neck grommet with one from Summit. When I filled the tank it leaked. I have my original grommet that I removed from my original tank and the diameter of the rubber on the inside is 3/8"...

I found the part and purchased it. Thank you

I have a new unused gasket set for the medallion if you need it, just PM me. I'll take a picture of how the medallion is secured to the underside of the deck lid and post her formyou to see. The medallion has 3 pegs which accept the standard fasteners.

The Dodge Bros. had an original hold down fastener which they kindly sold to me. Thank you !

Do you happen to have a photo of the spare tire hold down bolt that slides into that slot? I am looking to buy one as mine is missing. Thank you.

I am looking to buy the threaded rod and nut for my 67 Charger spare tire assembly. I find the "hook style" for 1968 and up but not for a 67. I have found another post on this forum from two years ago and it shows a completely different hold down bolt, see attached photo. Has anyone had the same...

I used 3M double stick tape. They make a thin tape just for emblems.

Yes I am aware of that

It turned out that the brake switch had continuity and is good. The problem was no power to the pink wire that attaches to the brake switch. I couldn't find the source of the pink wire not receiving power, so I used my pink wire which goes to the glove box light, attached a female connector...

BE VERY CAREFUL WORKING WITH THE POWER PACK, IT WILL GIVE YOU A JOLT FROM THE 200 + VOLTS AC ( I'VE READ IT CAN BE AS HIGH AS 330 VAC). I HAD SKATPAK REBUILD TWO POWER PACKS FOR MY 67 CHARGER. BUT EVEN WITH A GOOD POWER PAK, THERE ARE OTHER FACTORS THAT WILL PREVENT YOUR EL LIGHTS TO WORK. I...

Yes the clips look correct.