Search results for query: *

Pulling from a 1986 d150. Almost got it started but seems something is holding it back. Asking $1.00 for it. Free if you pull it. Condition of drivetrain unknown. Does have a new starter and alt. Truck is located in Gibsonville, NC. No shipping. Thanks, Clint.

Pay shipping and buy me a Rootbeer. Thanks, Clint. Probably more to be posted. Cleaning out garage again.

Thank you for taking the time to pull me back up. Spent some time this weekend working under the hood. Was able to get the AC compressor mounted. Didn't know if it was going to fit with the tunnel ram setup. Made some notes and planned my next step. Thanks again. Hope to drive it in the...

I will be 60 next month. Not too old except I never thought I would make it this long. Lived a very active and stupid younger life. If it had wheels I wrecked it. Now I am paying for it every day. Lots of stories and scars and regret non of it. So after a few hours of wrenching it is hard to...

It is too easy to let it set and end up stacking stuff on it. I did spend last Sunday cleaning off the hood and was able to see the engine. put it on jack stands. Rolled under the car to get an idea of what needs to be done. Have to finish the exhaust, work on the trans lines, get the shifter...

Thinking about selling my stalled project. 1967 Plymouth Belvedere II Hard Top. We have so much going on I do not have much time to get back to working on it. This is not an easy thought but don't want to be one of those people that hold on to something just because i MIGHT get back to it. It is...

One more week then back on the shelf. The space would be nice.

This did not go through. Still for sell. Except the dual quad intake.

Gen III hemi swap components. I have everything except the mounts to put a 5.7 hemi with the 545 transmission in a vehicle. Was planning to put in my 4x4 truck but life changes plans sometimes.Have an 06 long block, complete rebuild kit. New pistons on the rods. Rebuilt heads. Polished crank...

Good morning. Is this kit for vvt or non vvt?

Looking for the hood striker that goes into the hood latch. Must have lost the one I thought I had. Thanks for any help with this, Clint.

Thank you for showing up on such short notice to help clean out my garage. Ended up with a lot more room after all the stuff I dug out was gone.

Looks like I have a taker. Will update if this changes. Thanks b body's.

Cleaned out. Sorry.

Anyone that will come by this weekend. I have two sets of big block heads. 906 need rebuilt. 516 have been rebuilt. 67 b body steering column. A few distributors for b engine. Car oil pans orange ignition box. And a few more things I am digging out. In Mebane NC.

Good morning everyone. Can anyone explain why there is a difference in compensation ratio between the 03-05 and the 06-08 hemi engine? Thanks for your knowledge. This is the 05 and 07 specs from Alldata. Clint.

Sounded like a good idea. It shall be belt driven. Just have to collect a few different pulleys. One belt at the moment. No power steering.

Good evening everyone. Just found out today there are 12 volt A/C compressors that can be mounted anywhere on the car because no belt is required. Does anyone have information on this option. Would make things a lot easier for my system. Thanks, Clint.

Mopar does not have a circuit that stay's hot during the starting process. I installed a small switch panel. You always need a few switches in the car for something.

Found the two small pieces that were missing from the heater box.I don't feel comfortable with trying to repair.