Search results for query: *

I am replacing the door and QTR glass on my '70 RR hardtop. The AMD door glass fit ok. The AMD QTR glass not too good. Granted, the qtr window mechanicals were in a bag when i bought the car, but it was all there. I have looked at countless pictures and videos and am sure I have the mechanicals...

Trying to figure out a couple of holes that are in my engine bay. '70 Roadrunner - 440+6, 4 speed. See two attached pics. 1) In the first pic, the hole in question (orange circle) is between the two well know wire harness straps. This spot is hidden in all engine bay pics by the battery. 2)...

Does anybody have experience with AMD door and QTR glass. I have read plenty about the back glass. I have a full set of glass from ECS that I bought new 4 years ago. Front and back glass are OK and made them work. The problem is the side glass. Too much curve on the door and qtr glass. Door...

Does anybody have pics of the position of the ends of the drip moldings when they are installed? In particular the lower end of the windshield post and at the end the trim above the door where it meets the curved piece in back. Does the rail trim above the door overlap the curved piece in the...

I almost hate to ask, but I need a good YouTube or pics for preparing the door glass channel seal. There should be lots out there on this, but I cannot seem to find much of anything useful. These are pricey and don't want to screw them up. I know I need to punch holes for the guides, just...

Just installing new weatherstripping on my '70 B Body Hardtop. The weatherstrip was supplied long at the end toward the rear. The question is where does that get cut off in reference to the roof rail itself? Or does it matter? Any pictures would be appreciated. Thanks, Wallace

The quarter window roller assemblies on my '70 RR Hardtop are frozen. Started looking at it and is pretty easy to take them apart to clean and lubricate. The main issue is the flat plate that secures the ball stud and the spring clip. It is held on by two rivets. If you grind the rivet heads off...

I have a '70 RR hardtop and was missing the SS trim between the qtr glass and door glass. This piece actually mounts on the door glass. I bought a L&R trim from a salvage yard last week. As luck would have it, I found the ones that came with the car when the package arrived. I am not saying the...

I have managed to figure out what every hole and cutout is for on my '70 RR. EXCEPT for one! It is a 4-speed, w/ air grabber, no a/c, manual brakes and steering, Rallye dash w/ a 440+6. The hole I cannot figure out is in between the speedo hole (7/8") and the oval cut out for the clutch rod...

May be a stupid question but want to confirm the VIN decal location for a ‘70 RR. I think it goes on the drivers door below the door latch. Please confirm! Thanks, Wallace

I am trying to see which type ink is best when stamping the heater box, radiator and the cooling fan. I have the stamps, just would like to know what is the best ink and where to get it. Attached is an example of a stamp on the cooling fan. Thank you!