Search results for query: *

I measured the resistance from one positive terminal to the ground terminal and they all are reading between .8 ohms and 1.5 ohms. I had taken one motor apart and it runs with the gear drive part removed so I cleaned up the output drive shaft and bore and it spins freely by hand. Once I install...

I actually find it harder to understand the listing from your manual. Where does the description for the part number 2822 880 end? If it is just the top two lines then it looks as if that could be the part number for the bezel for my car. Although I don't understand what "Cluster, V, R-L...

Also, 2650lbs sounds low for what I've seen, unless the fiberglass is insanely thin and light. Uncle tony has a 4 door 72, which is a bit heavier so that adds to some of it and he is full steel but he has the thing rattling and shaking apart almost with cutting brackets and supports with...

Got a bit more info today. The springs I have, were suggested by Compcam the folks that made the cam. They may not be double coils, but as you suggested, a round outer coil, with the inner flat coil. I should make it home to my Island tomorrow. Will do more checking and have pics Thursday.

Stefs fabricates beautiful pans. Fortunately mines covered with a daiper so no one see it. Doug

Today I tacked the stubs together then tacked the mate flanges to the mufflers. Keep fitting pipes tomorrow. Going to Santa Maria on Thursday so I'll hit my new supply place. I need more stainless filler rod to complete the welding of stainless to mild steel. I had some 319L stuff but found I...

I have a non A/C that I pulled out of my '64 Belvedere last July. Everything worked fine. I'm in SE Pa. Jim

Anyone have a minty 67 belvedere hood latch and the piece that slides into it to release the latch

Nice. I have a subscription to Modern Rodding. Great magazine, way better than where they were working before. I'll be watching.

Not me. Don't think I ever have. Now... I HAVE watched Puppy Bowl!

Excellent gasket, great if changing rear ends frequently. But a couple of cautions... 1.Be sure the mounting surface is totally clean on the diff and housing. 2. When torqueing it down do it in (2) steps, the 1st @ 1/2 torque spec and 2nd final torque spec. Just my $0.02... :thumbsup:

The Aeromotive in tank pumps also very quiet also

For Charger I presume... I have the OE out of my Bee somewhere. No trunk light...

160 mph was your trap speed running mid 10’s on 4:30 gears? Something doesn’t add up. I would have to see the time slip to believe 160mph.

Need the complete harness from the kick panel & into the trunk, including switch and light socket. Thanks.

Not mine No vin's in the ad. 2 1979 Chrysler 300s 6500$

66-67 Coronet mast and maybe Plymouth are the same. Coronet/Charger will have the same bezel.

There's always the alternative: The Puppy Bowl XXI. https://www.discovery.com/shows/puppy-bowl

The BEST thing for you to do is use the information provided by 72roadrunnerGTX, for this gentleman has explained how the system operates, with examples. If you, personally, have any comments or questions of the application of electrical engineering and system calculations including of how...