Search results for query: *

As long as the balancer is pre 71, the bolt pattern is asymetrical. The power steering pump is the issue for belt width.

Why is it any different than letting 7 year olds moto cross or go cart. Same **** with the odd sad outcome...

Indeed! Then this inevitably happens...

I see the 3/4" (give or take) spacing but can't picture how that goes in there, unless the big tunular spacer is narrower by the thickness of the flat piece? Also, since you were kind enough to reply, do you recall what part number your compressor mounting brackets were?

The block is late 1969. Forged crank.

Who knows! My 69 Bee's SPD was Feb 25th and the engine wasn't built until the 27th and the exhaust manifold on one side was cast on the 28th!

I only saw one…. But I’m not picky

Hood has to be off. An alternative: if you're planning on also updating the suspension, drop the engine/trans from below, still on the K-frame. I just did the drop on my Dart as I'm updating the suspension and replacing the clutch and pressure plate while rebuilding the engine.

Your question could be answered with some detail if you provided the vin of your bird. These casr were built over a few months. Early versus late would have different date codes. In general, manifolds should be dated in the 8/69 to 11/69 range. With 11/69 being late for some cars.

68 or 69. They are different. Here's a 68 with 3/8 ps belt width. (Inbox is full) Always have to ask, what year motor?

Why ?? :poke:

Clean and verify. Shift selector seal is another common leak spot. Any leak can be repaired but ATF is really thin and travels well so the most important part is verifying where it is leaking.

I think it should be considered wreckless child endangerment to let a 7 YEAR OLD drag race. She should be driving bumper cars at that age not a dragster. I feel for the girl that was taken away as a result of her narcissistic parents poor decision. This should never have happened. JMO

It was cool having a Charger for our family car!

Is this seat missing any springs, clips, or hardware other than the one chrome knob? Does it operate smoothly? Any chance to take a photo of both sides of the seat track bottoms that touch the carpet? Thank you, Mark

I tried to smoke but wasn't any good at it. EVERYONE in my family smoked except my Grandmother. Parents, uncles and aunts, siblings too. The guys in movies and TV shows looked so cool with a smoke hanging out of their faces....the Clint Eastwood type squint they had made it even cooler. I just...

Who? What? Where? When?????????? Never saw that one...... Now if you want to talk about "Rowdy Yates" who played next to "Gil Favor" in "Rawhide" then I can relate to ya Budnicks! :poke:

The trans needs to be thoroughly cleaned and dried. Then puff some baby power all around and above the pan rail. where does it get damp? Is it really coming out of the bell housing? Or is it leaking elsewhere and running off the bell? If it's coming out of the bell. Not many possibilities; Pump...

Try a left hand bit when drilling it out. Might get lucky and unscrew it.

Yup. That's where I got my adapter plate. OP, you will need to get a look at the shape of your factory speaker to get the right plate.