Search results for query: *

1967 Coronet R/T 440/Auto Non-A/C Manual brakes I cant figure out what goes through this factory hole in my firewall. I've seen a single wire with large grommet on other B-bodies at car shows. I asked the owners but they didn't have a clue where it went or what it did. They must've bought not...

67 Coronet R/T Where does the clip go to hold the trans cooling lines? Looks like it attaches to the bottom left trans bolt but the lines don't jive with the location of clip. Anybody have a photo of this thing installed? I could make one but i already bought one from Inline Tube.

1967 Coronet R/T. Original 440/727/8-3/4. I removed the driveshaft to replace the u joints. Both seem to be original. They u joints were very difficult to remove so they got thrown far far away. I ordered new U-J according to my make/model with all the usual sizes being listed. I have...

1967 440hp -All new engine wire harness for Big Block with points. -New MSD ready to run distributor -Blaster 2(black) coil -Msd plug wires First start ever for breaking in the Cam. Kicked right over. Turned off for water leak. Kicked right over again... turned off for fuel leak(30 mintue...

I have 1967 440 HP motor. It recently has been fully rebuilt. All new internals. I installed the original Harmonic Balancer with no problems. I went to find TDC by using the thumb over the hole whilen cranking technique. When my thumb blew off I looked at the mark on the Balancer and it was...

I'm missing a spacer for my alternator bracket. It goes between the Cyl.head and Alt. I would much rather make one vs buying an entire kit. Which type of piping is made from? I tried looking around at all the hardware stores. Nothing with a 3/8" inner diameter hole. Any help would be...

1967 CORONET R/T. Looking for a single or a matching pair of Qrtr mount R/T emblems. Anything in ok condition and better will do. Thanks.

Hello, I have a 1967 440 hp and I lost the pipe plug for the fuel pump push rod. Where? I dont know? What's the correct NPT size? Any help would be greatly appreciated!

Looking for patches for the lower rear of the front fenders. I know the make new ones but they've been out of stock for a long while. If anyone has any used pieces or patches they never got to use please let me know. It's the only thing holding me up from competing the body work and painting it!

Looking for a deep aluminum trans pan(newer the better) and a dipstick w/ tube. I live in Delaware. Please send pics. Will pay to ship. Any help will be greatly appreciated. Thanks!