Search results for query: *

Yes dadsbee my bad Thought you used VHT Thanks for your help!

This question is directed to dadsbee A while back I saw a thread that you used aVHT roll bar and chassis black for your cleaner base Was that a satin or gloss ? Thanks in advance dcmason69

So is that where yours sits at Dadsbee 9.375 I see you have the ramcharger l am figuring over all height which includes post! Just making sure before I buy a AGM battery. Thanks for the info

Well that’s good Concerned about clearance for ramcharger Can any one else confirm this? Looks like I am good with a 8 inch battery height! Thanks 68 RT

6.8 wide 10.75 long

What is too high battery for a 69 Coronet N96 hood? Can a person use a 8 inch tall battery and be ok? Looking to put a AGM in

Ok will try Thank you

Thank you toolmanmike The question I have with this is anyone gotten this item? Is it for imprint certain the correct diameter’s The place selling it does not state any info so I need more information!! Thank you for your reply.

Joey How do I empty my in box Said Ian at my limit of 15 Thank you dcmason69

Any one have a source for the correct size washer squiter hose for 69 Coronet? Measures about 1/8 Id. 7/32 Od. Thin wall. Thank you dcmason69

The nozzle hose across cowl has 2 holdown clips do they both point back or the right side foward and left side back ? What is right dadsbee? Thank You dcmason69

Thanks dadsbee that’s what I figured Will see what it looks like after I strip off old paint ! May just foof some brite zinc on small bracket and spring will see what rest looks like natural after using paint remover. Thanks for the reply!

Restoring rear license plate bracket on 69 Coronet, what did these look like from factory as far as paint or plating? Had to take mine apart from the pivot pin and spring in order to straighten both pieces has old black paint on back side but I don’t believe it’s correct! Any help...

Ok 1 Wild R/T, was just an observation. Just want to check everything out before making any decisions. I appreciate your input and advice. dcmason69

So looking at the K 7103 offset looks like in the picture that the end cap large and small washers do not have the seriations made into them! Like the factory or even the generic ones so how do you keep them from turning? Other than tightening them Up really well? dcmason69

Ok got it! Thanks again to everyone.

Great info 1 Wild R/T Thank you all for sharing your experience and knowledge this is a big help for me. Maybe one more question R/T Do you get 2 offset kits to do all 4 corners or 1 kit and do just fronts? dcmason69

Wait I ment positive!

Thanks RT So is that I assume negative caster?