Search results for query: *

hello all I would like to install a gen 2 hemi with Schumacher conversion mounts to a big block b body k frame. Motor has an external Milodon external oiling system with feed out from pump towards the motor mount. I was warned there will be problems getting hose and nipples to clear the motor...

p4532267 intake anything special about this intake? thanks

hello gang p4532267 hemi cross ram anything special about this intake? want to put two holly carbs on any suggestions on a throttle linkage set up from a vendor for two Holly's thanks sjm

hello all are there any lock washers or washers under allen bolt fasteners for cross ram intake thanks' sjm

hello all what is the diff between hemi engine wiring harness verses a standard 383/440 motor thanks sjm

hello all are cross ram fasteners all the same length? thanks

hello gang have 383 automatic RR just put a carb on motor with electric choke ant suggestions on where to get proper source of 12 volts thanks

question how street friendly is a cross ram two four on the street. any differential gear suggestions? isky 520 lift cam automatic thanks

hello all any suggestions for 426 hemi holly x2 cross ram air cleaners that will let me close hood if possible - stock hood 69 RR thanks

hello need help have 540 stroker kit from bill mitchell new block 4.5 bore a isky cam nothing big is it unusual for crank gear be 6 degrees retard to get the cam card specs? thanks sjm

motor has been converted to electronic ignition i always smell like gas after a round to town (rich) what is a general turn out from seat on mixture screws? does turning in screws lean motor / to avoid the rich smell what is the best timing adv or retard thanks sjm

hello gang Need some help with carter carburetor i have a 383 69 RR when i get a decent idle in park as i drop into gear it really drops close to stalling out. If i increase the idle in gear when in park it races and wants to diesel on hot days. any help would be good thanks sjm

have a new set of gen 2 re pop cast exhaust manifolds any suggestions on how to keep natural cast finish i hear some chatter on graphite stuff would like to keep natural as possible Eastwood stuff ?????? thanks sjm

its me again purchased a set of speed master adjustable rockers / the bolts that hold the shaft on the head with the stand bottom out in the head can NOT tighten stand down what am i doing wrong wrong??? used some shorter bolts laying around to mock up and when snug some rockers are rubbing...

ok fans i can read all day long on preload on hyd cam adjustable rockers 1/4 turn down after zero lash 1/2 turn down up to 1 1/2 turn 340 fresh build only change single adjustable rockers any guidance on after zero lash how far down on adjuster thanks sjm

hello all any suggestions on a distributor for street 540 hemi thanks sjm

thanks for the reassurance will only be using a isky solid 520 lift cam on street thanks all

picked up new mega Siamese block was told this block was set up for a high lift roller lifters ??? want to use for street any harm thanks

be glad at least you have a fender tag what a pain with out one looking for a company that can reproduce know any thanks sjm

hello all have 1969 rr with missing fender tag but have the original build sheet anybody know of any current active companys that can reproduce my fender tag? thanks to all sjm