Search results for query: *

So I’ve restored the steel front grille mounting surround from my 69 charger, and the next step will be to restore the plastic grille itself that mounts back into the steel frame. I’m looking for hints or tips on things like how to go about removing the fasteners that hold the stainless trim...

Wrapping up the restoration of the dash from my 69 charger while it’s out of the car. When I bought the car the glovebox was open and wouldn’t stay closed but I didn’t care as the car is getting a full resto. Now that I’m finishing the dash, I do care and I can’t get the glovebox to latch. The...

I’m restoring the dash out of my mostly survivor 1969 charger. Mounted to the bottom of the dash is this speaker switch which is basically a rheostat, so I’m guessing it’s a fader switch? My car does have rear speakers but they are round so I’m assuming they are not originals. Is this switch...

I’m in the middle of restoring my plain Jane 318 69 charger car, as well as the dash. The dash “medallion” that goes at the top of the dash between the tic tic tac and the speedo is long gone from my car. I see there are a couple of options out there that are referred to as “early” or “late”...

I’m restoring the dash out of my 69 charger, and I’m just about to paint the black plastic radio bezel. I’m looking at the letters on the bezel (vol, tune, on, off, tone) and I can’t tell if the raised letters should be white or silver as the bezel is in need of freshening up. My guess is that...

So I am tire shopping for my 69 charger that I am restoring. I am keeping the car stone stock and I am about to restore its magnum 500 rims. In keeping with the original slash stock theme I am looking at putting white line tires back on the car, which is what it had from the factory. I’m looking...

The black plastic decorative dash piece that goes above the glovebox on my 69 charger has a warp in it out towards the drivers side end. Other than that, the piece is good and re useable. Does anyone have any suggestions on how to straighten it back up? I was debating very carefully warming the...

I’m restoring the dash out of my 69 charger, and I’m at the point of wanting to refresh the black plastic pieces including the gauge cluster piece. Can anyone tell me what sheen of black paint would be factory correct on these plastic dash pieces?

I am restoring the front grille on my 69 charger, and I have been testing my headlight door vacuum actuators with a vacuum pump. My drivers side actuator is not working. Is it possible to rebuild these things? Also, my passenger side actuator has a bend in the end of the arm, while my drivers...