Search results for query: *

I'm looking for a 5" pulley to fit a 1970s era Saginaw power steering pump. It needs to be the type where the pulley is held on with a nut, like shown: I have a pump with the 5" pulley but it uses a different shaft: Dirty, covered in old paint...not a problem. I will sandblast and...

I need a section from a fender to repair an otherwise serviceable '70 Charger fender. My "Jigsaw" Charger came with this fender: The fender is good overall but is damaged at the door edge. I can straighten it but I need the reinforcement brace seen here: It appears that a left fender...

Hello, I need a floor console top plate for a 4 speed model. No heavy pitting but bad chrome is fine. I intend to prime and paint it. I'm doing a 5 speed conversion and the automatic plate will not work even with modification. I have PayPal. Please PM with offers or suggestions. The plate can...

I am converting my 727 to a Tremec 5 speed transmission and I need the 4 speed manual shift top plate for the Center console. I also need the console door and the small section after the door. Driver quality is fine....Of course, value is dependent on condition but I may consider aged and...

I am looking for complete 10 inch rear drum brake assemblies to fit the 8 1/4", 8 3/4", 9 1/4" and Dana 60 car axles. I'm also interested in Parking brake cables IF the outer jackets are not rusty. The years that I need are late 60s through the late 80s. I have PayPal. Shipping will be to...

Hey guys and gals... I have a "Speed" Demon 850 4 barrel vacuum secondary carburetor and I need all the ELECTRIC choke parts for it. Years ago, I stupidly pulled and trashed everything from the choke plate and rod, the linkage, everything. The Charger can now be driven in the winter and I want a...

Hey everyone, I have a few axles here and need to get brakes on them. I want to use 10" diameter, large bolt pattern. The shoe width isn't crucial if you have the drums to go with them. I understand that there are a few different styles so no matter what I do, I will want a matched set. It is an...

I am putting together an 8 3/4" axle and I cannot find the brass brake "T" fitting that mounts to the housing. The housing is from a 1970 Polara but I suspect that this is a fairly common part. These housings vent through a hollow bolt that secures this fitting. I need TWO in case I lose another...