Search results for query: *

Looking for a set of pit - free 11" Rear backing plates for a 68 - 70 B body. They must be pit free. What's out there? Pm me here. Thanks for the ad.

Looking for bolts that hold the seat tracks to the bottom of the seat in a 70 B body. There are 8 bolts total. Also I need 1 (one) bolt (stud) for the bottom of the seat track that goes through the floor for a bucket seat bracket. I don't know, they may all be the same. What does anyone...

Guys, I'm looking for two of the "clips" or "mounting clips" that slide over the bracket that is welded to the bottom of the door where the bottom adjuster for the vent window frame goes through and is tightened down. It is a square piece (approximately 2" square) that is bent over it's self...

Wanted: Rear spring shackles for 70 Road Runner / GTX. Very nice to mint or NOS only. Preferably complete with nuts. PM me here. Thanks!

Looking for an NOS 1970 only Key cylinder and door lock set or just the key cylinder. I prefer NOS, but very nice or excellent used may do. Thanks for the ad.

Wanted: NOS 14" Brushed trim rings. PM me here. Thanks for the ad.

Looking for a 426 Hemi crankshaft. One that is in nice condition. Not cut down or cut much. PM me here. Thanks for the ad!

Looking for a set of vent wing frames for a 70 2 door hardtop. I need a set that has excellent stainless trim where the window glides up and down. I'm not really worried about the pot metal. Who has what? Email me at: trdeppen"at"comcast.net or pm me here. Thanks for the ad.

Looking for an unstamped "over the counter" or Warranty 426 Hemi block / engine. Looking for one that was cast after October 69. I'm not interested in one that is all cracked up, welded up, etc. What's lying around out there? PM me here, email me at: trdeppen"at"comcast.net, or 7one7-571-5one80...

Looking for a woodgrain radio bezel for a 70 Ralley dash. For an AM radio. I do not need the plastic piece. I only need the metal faceplate with the woodgraining and tabs. If you have both, that is fine. What do you have?

I'm in need of the nut that is welded to the fender where the front hood adjuster bumper screws in to. Anyone have a trashed fender they can cut one off of?

Looking for a waterpump housing with a casting date of 6, 7, 8 of 69. Thanks for the ad! I should have posted the casting # 2780987 along with a pentastar cast into the lower water neck.

Wanted: Starter with a casting date code of 5,6,7 of 69 and an assembly date of 7 or 8 of 69. Thanks!

Looking for a woodgrain radio bezel for a 70 ralley dash. Also the two lower woodgrain end caps for the dash. Condition of woodgraining is not critical, but I don't want cut, damaged, or bent pieces. Also they MUST HAVE the backing plate with the tabs on that go through the plastic and bend...

Some 70 NOS GTX parts that I need: NOS 70 AM radio woodgrain bezel for ralley dash. NOS 70 woodgrain lower end dash pieces (both sides). NOS tail panel trim pieces.