Search results for query: *

I'm looking for a presentable reasonably priced RR trunklid emblem. It doesn't need to be perfect - just affordable, unlike the reproduction emblem. Thanks.

I need the three strips that go between the rear bumper top and sides and the car body. Thanks.

I'm looking for a good two-speed wiper motor that will fit a 1973 Road Runner: one that moves the wipers back and forth (when turned on) as well as parking the wipers against the stops on the bottom of the windshield trim when they are turned off.

I need a fairly straight one of the aluminum moldings that fits on the bottom of the grill for one of these cars. Thanks.

I need seven of the 5/16"-18 nuts with the built in LARGE (over 1" dia) free spinning washers that were used on the back part of Mopar car fenders to fasten them to studs on the inner structure. I don't know what years they used these, just that they were used on a number of different car models...

I'm looking for the plastic panel that the rear seat rides up against on the lower left (driver's) side, sometimes referred to as the lower inner quarter panel. Mine is pretty trashed from sun and abrasion damage so I would like to find one that has most of it's surface unblemished. The interior...

I'm looking for a two hole firewall grommet like this: . It's about 2" long and goes in about a 3/4" hole. It is used to route the climate control switch vacuum wires thru the far left side of the firewall. It might have also been used to route large wires thru the firewall on some cars as well...

I need the moldings that go around the edge of the wheel openings on the left and right quarter panels, and also the rubber/plastic inserts that fill the space between the back panel and the rear bumper. Thanks for any response or leads on finding these parts.

I need just the rectangular device with the two male blade terminals on it and NOT the choke heater. I don't know what years they used these but I believe all engines used the same one in 1973.

I'm looking for this pulley and I believe this is the correct part number. The diameter of the pulley should be around 5 7/8" and the overall thickness around 1 3/4"-1 7/8". That would put the distance from the mounting flange to the center of the groove opposite of the mounting flange in the...

I need an EGR valve for a 400/440 high performance engine (with the thermoquad carb). The mounting holes are about 2" apart center-to-center. Thanks.

Looking for a rust free decklid in the central US (I'm in Kansas). Thanks.

Near as I can tell these were used on '73 1/2 and up B bodies with A/C or HD cooling after Chrysler transitioned to 28" radiators from 26" radiators in 1973. Horizontal distance is 28" between mounting holes, vertical distance is 12 1/2 to 13" between holes. Thanks.