Search results for query: *

What seam sealer to use in roof gutters , how it wrote down a while back but lost it somewhere , believe it was something about self leveling , used Wurth on inside body seams . Thanks

This is on a 63 b body , got all the seam sealer off the whole car except in the roof gutters , this isn't coming off like the rest of it did , try heat gun , no go , wire wheel . putty knife ,razor knife , screwdriver takes forever and still can't get it all , it's different seam sealer then...

Have car on rotisserie , turn car clockwise at 2 and 4 o'clock it will stay on it's on, get to 5 o'clock it wants to go to 6 o'clock and beyond in the vertical position by it self . I stop it at 6 o'clock position , Question is it top heavy or bottom heavy ,do I raise it up or down ,it has a...

His anyone use eastwood doorskin tool 23110 , looks something like big pliers with nylon pad on one side of it , hammer and dolly so far then use this tool to finish crimping the flange on door skin ,asking anybody out there if this tool works . Thanks

This is a 1963 Plymouth savoy , the hood won't shut tight at rear corners toward windshield , there about quarter inch to high can push down on corners and there perfect , weak springs ? Thanks

Butt welded trunk pan in , grind welds down , put light under trunk to see where pin holes is . problem is when i weld pin holes up it gets one be side of it not getting anywhere . Try turning heat down but then i get mounds where it isn't hot enough . Need advice . Thanks

Was going to strip body down to bare metal than somebody mention to me to just scuff up old paint than apply epoxy primer sealer . Told me if you sand to metal it would take off some kind of coating that's keeps the metal from rusting . What to do ? Thanks

Trying to paint the underneath of car on lift . Using hvlp gravity feed spray gun with 3m cups and liners . Not working to well , any ideas would be helpful. Thanks

Just got under coating off and wire wheel and sanded under floor pans . What's the best stuff to remove residue before paint . Have wax and grease remover but not be tough enough to remove residue . Thanks

Was using epoxy primer /sealer over bare metal over the summer ,now sense it's cold what can i use to cover bare metal . They say don't spray epoxy when it's cold . It's in a garage, but it's not heated all the time. Mostly when I'm out working on it .So what can i use to cover bare metal to...

Going to buy paint. The color is light turquoise code jj1 1965 . But it isn't metallic paint. Can i mix metalliic into it ? Ask TCP Gobal , wasn't very big help. Base coat /clear coat paint. Thanks

Replacing the rear quarters on 63 bev. Trying to figure out whats the best way. Top half of old quarter good. Should i just go ahead and replace whole quarter or cut across so far up , if cut so far up ,where should i make the cut at. Thanks

need help on grinding welds in tight places. try using long shank grinding stones,useless. can,t use grinder with different wheels won,t reach or fit. to noteable to leave it as it is. any suggestions? thanks

putting in new front floor pan , drivers side. on 65 ply. sate. the question is the old floor pan had about a 1/2 inch hole right next to the dimmer switch. no plug was on it. any ideas what its for? to high for a drain hole, to low for any thing else. thanks.