Search results for query: *

Anyone tried Detroit Muscle Technologies Door Seals & Roof Rail seals? What did you think of them? https://www.detroitmuscletechnologies.com/mopar-b-body-66-67-belvedere-charger-coronet-2dht-roofrail-weatherstrip-set/

Where's a good place with good prices to buy stuff like masking tape, plastic, masking paper, etc? Which 3M tape do you use for general automotive masking? Any recommendations besides 3M for masking tape?

Anybody bought these for a 67 b body? Do they have the stainless steel strip on the edge? Emailed a vendor but got no response.

Pulled the windshield from my 66 Coronet project and have a few questions. Pic is the driver side lower corner where the cowl and a-pillar meet. Passenger side has the same issues. The rest of the channel is nice and solid. 1. Thinking of cutting out and replacing the part circled in red. I...

Finally got around to trying molasses + water as a rust remover. All i can say is wow,, it works great and it's cheap! $3.75 per gallon at the bulk animal feed store. My mix was 9 parts water to 1 part molasses. Put the rusty parts in a 5 gallon bucket and it's been 4 days but virtually all the...

Anyone ever used summit racing epoxy primer and are you happy with it? I've been told SPI epoxy primer is great but it's over 2x the price. What would be the benefit of SPI over Summit? Basically just need to sand down and coat bare metal. $275 - SPI epoxy + activator 1:1 $125 - Summit Racing...

Anyone have good tips on cleaning debris below the quarter windows down low behind quarter panel. There's a small gap back there that's hard to reach down into and it's got leaves, dirt, and who knows what else.

Has anyone ever cut out a section of the quater panel to do wheelhouse repair and then re welded the cut out piece of quater panel? Any tips on this like cutting wheel thickeness? Also want to do this because i can see chunks of factory undercoating peeling off with rust behind it and it's...

Looking for recommendations on good brands and good bang for the buck sandpaper for body work. Also what brands to stay away from. For 6 inch discs and for block sanding. Thanks

Need to take down to bare metal and epoxy prime for the first time. What are some decent brands to look into or they all pretty much the same?