Search results for query: *

Im parting out a Dakota 4×4. The front driveshaft is presenting some problems. The bolts holding the caps on the double-knuckle at the transmission end are siezed. They are a 7 or 8 mm head and going to round off.Clearance is an issue & only a open/box wrench will fit on bolt. Do I heat the...

Quick! I just dropped the motor in last night. Can't get flexplate bolts to line up. The first bolt goes in but the next is off by 1/4 hole. This goes for all the holes, tried them all. Torque converter is B&M Flexplate a generic Napa I'm pretty sure that I didn't put the flexplate on...

I put this set on my 440 yesterday. First of all, I had a heck of a time getting the two bottom bolts on each cover in. They wanted to get too close to the cover and couldn't get a socket or wrench on them. Has anybody else had trouble. Also, there's no place for a breather, how's the motor...

Here in a few hours I'm going to go install my Rocker assy onto my 440. Will be a first for me, any advice do's, dont's, tips, links would be helpful. Mild hydraulic cam, Crane gold adjustable rockers, 452 heads. Pushrods are from Comp and same length as stock Thanks

The rocker assys that came with my motor are too worn. A few months ago I brought a good set of crane gold rocker assys from a member here. They will not work with the pushrods I have. The new rockers are the adjustable type and need pushrods with cupped upper ends.They current pushrods are...

This is my first Rodeo with a Big Block Chrysler of any sort. I'm getting ready to drop the motor in this week and advice would be nice. When I place the motor, the only thing that need be on the block are the motor mounts correct? I can place the oil pump after the motor is set. Secondly, I...

I'm going to try and get my Coronet mobile this month. I was given a torque converter (nothing special) with the car. I plan on just installing it but is there anything I should do with it. ( clean it out?) I was told it hasn't been with the car since 2008. And it appears dirty like it wasn't...

I recently purchased an old tractor. I'm cleaning the sediment bowl out every few hours of use. I'm not wanting to remove the fuel tank. Until winter maintenece6 Is there any product I can add to the fuel that will safely dissolve and blend the algae with the fuel? I can disconnect the fuel and...

I'm changing a wheel bearing in my Dakota. Got everything out and cleaned. Do I put locktite on the bearing before I put it in. Also on the inner cap bolts or the small bolt that holds the pin to the carrier assy in place. Sorry if my words aren't correct but y'all know what In talking about...

Replacing my fuel module/ lines on a 95 Dakota. Napa/O'Reillys only sells precut lengths at $35 apiece with straight coupler. I just need a few 12" pieces without the coupler. I want to custom make a fuel line with a 90° coupler.