• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Search results for query: *

  1. old guys rule

    Propane conversion

    Anyone out there familiar with propane conversion for an engine? Or maybe a source of information?
  3. old guys rule

    8 and 3/4

    Has anyone reused the pinion nut on an 8 and 3/4 center? Is it safe?
  4. old guys rule

    Pinion nut torque

    Would someone out there tell me exactly how they go about torquing (twerking)? the opinion nut without a special tool. Thanks, Dave
  5. old guys rule

    Chunk leak

    Installed a fresh 8 and 3/4 center that leaked some gear lube from the pinion seal after refilling. Complete professional rebuild including new pinion seal. Could this be caused by overfilling axle?
  6. old guys rule

    Cam hardening

    Does having a cam hardened... I think it's called nitriding... Solve the problem for flat tablet camshafts?
  8. old guys rule

    426 wedge

    What year did it come out?
  9. old guys rule

    8 3/4 Lube

    All 8 3/4 centers take 2 pints of lube right? Thanks, Dave
  10. old guys rule

    8 and 3/4 breather valve

    Is there a way to test the breather valve on an 8 in 3/4 axle?
  11. old guys rule

    8 and 3/4 swap

    Swapping out the center section of my 8 and 3/4. Can pull the axles out only about 4 in is that far enough? However I would like to change the foam gaskets. What am I missing?
  12. old guys rule

    489 center section

    I have a 489 center section for an 8 and 3/4 that has been setting for years. Unable to turn the yoke. Is it savable?
  14. old guys rule

    8 and 3/4 yolk

    Changing a yolk on an 8 and 3/4 center section that doesn't have a crush sleeve eliminator will disturb the gears correct? Anyway To tell if an assembled center has a crush sleeve eliminator without disassembling?
  15. old guys rule

    U-joints

    What's the approximate torque for you joints? I have a tendency to overtake. German torque?
  16. old guys rule

    8 and 3/4 gears

    When polishing in a new set of gears to one another is it necessary to change the lube?
  17. old guys rule

    Oil filter question

    In your opinion, what's the best oil filters to use?
  18. old guys rule

    Cam overlap speck

    I have a cam with an overlap of 12° at 50. Anyone have a formula to figure out the usually advertised degrees of overlap? It's a hughs cam.
  20. old guys rule

    833 syncros

    Anyone had problems using synthetic lube in your tranny?
  21. old guys rule

    8 and 3/4 yolk replacement

    When changing a yoke on a 489 8 and 3/4 center section with a crush sleeve eliminator is the pinion gear adjustment Disturbed?
  22. old guys rule

    8 and 3/4 yokes

    Can anyone tell me all 8 and 3/4 yoke sizes and how to measure them?
  23. old guys rule

    Cruise control for carbureted engine

    Anyone out there no anything about cruise control systems for a carbureted engine?
  24. old guys rule

    Oil pressure sending unit

    Can anyone tell me what oil pressure sensor I need for a Bosch mechanical gauge?
Back
Top