Search results for query: *

I have a 440, stock bore with a cam, dual quads and headers. It also has a Melling HV/HP oil pump and pegs the gauge when the engine is started. The previous owner used Valvoline VR1 10-30 AND added a can of ZDDP. I am considering VR1 in 20-50, Can you have too much oil pressure?

I recently purchased a car with a 76 440 truck engine. I just discovered that the valve covers were the early 4 bolt type. Although he said stated "The heads have been milled .030, port matched and had the bowls blended, and had a valve job" he never stated he replaced the heads. Where these...

Hey guys I need opinions on the best way to install this linkage to get the easiest push. In your answer give me the hole number of the pedal, then short arm on the crank,. then the long arm on the crank! THANKS!!!!!!LK

What would you estimate the HP of this engine? Thanks, LK The engine is a 76 truck 440 with 32,000 miles. I had the block ball honed and cleaned, and new cam bearings. It has new rings and bearings, and a new Melling HV/HP oil pump. New aluminum water pump housing and pump. The heads have been...

Any body ever try these? https://www.autozone.com/external-engine/valve-cover-gasket/victor-reinz-valve-cover-gasket-15-10522-01/1021730_0_0

OK I see all kinds of hurst shift handles in many different lengths and in rectanglular and round shafts but what was originally used in a 69RR? I want to convert my bayonett to a bolt on and get the same appearance as a factory unit. ...Thanks,,Ed

VIBRATION DAMPENER!!!!!!!!! LOL!, I have to replace my Vib D and the new one says I must use a VD installer tool, Its been a long time since I worked on one of these BB Mopars but I remember just pulling them on with the bolt...???? What Ya think???

I don't like the "play" in this factory style bayonet handle. Shifter handle, shifter, shift rods and trans levers are all new., Trying to tighten it up a bit. Has anyone drilled the Bayonet shifter and shifter and bolted the handle in solid to take out the play. Did it drill easy? It appears...

First question,,,, I have a 2468130 block (383) with 5-25-71 build date. stock bore, mildly built. Four speed. I always seemed to have a vibration in it. My thoughts came to light yesterday when the Harmonic balance came apart and began rubbing against the timing cover. I removed the balancer...

Can anyone take a stab at the HP this build should put out?" THANKS!!!!,,,Ed 1977 440 new rings and bearings. Heads have been port matched and bowls blended, milled .030 and had a valve job and new seals. Hughes Whiplash cam, lifters & matching valve springs..518/.518 lift 232/245 duration...

Hello. I have 69 rr with a mildly built 383 4 speed. It has a 3.23 open rear end. I am wanting to put in a sure grip with a lower ratio. I am running a 28 inch tall tire. I punched in the numbers to a gear ratio calculator and it said I need 3.46 gears so a 3.55 would be about perfect! Now I am...