Search results for query: *

Ok, I very carefully installed my wire set-up on my 727, making sure the hole on the carb lever was exactly where it should be (I took the special mopar bouchillion throttle plate to double check with.) I tested several arms (Different lengths) down on the throttle lever on the 727. I got a...

A quick question for tips on good valves,locks and retainers to get for a set of Eddy E street heads #5093. I was thinking Manley stainless with titanium locks/retainers? (Also, is a single lock groove the normal today? On my old 413 there are three grooves.) Thanks

Thinking out loud here when I am trying to adjust my Throttle pressure lever to work the same on my TQ (Thermoquad) as it did on my SD (Street Demon.) On my SD it worked great and was easy to adjust, I had instant low speed kickdown and high speed kickdown. ...I then changed to a TQ and the low...

Ive got a set of mopar Ductile Iron adjustable rockers for my 440 build. Now, I read something about special shafts for these with "banana" shaped holes etc? Ive not digged into rocker arm shafts before so please educate me. :)

Im trying to locate a set of rocker arms for my 440 build, though i want non-roller tips and those seems hard to find in 1.5 ratio? Is my best bet to hunt for old original ones or does anyone have a tip of a brand that makes this style? (Cranes in the pic are 1.6)

I do want to build my new 440 engine with lots of torque down low and that instant response from low rpm idle. I also want good vacuum (At least 15hg) and a smooth idle. Cam selection is still a mystery to me so my question is: - How far from a stock 440 cam can i go and still have the things I...

Im going to put in this new straight shaft as my current one on the drivers side is bent and wobbles. (8 3/4 axle, 489 housing. ) It is used but has a nice Timken bearing on it. Planning to clean it thoroughly and grease it up. Im also planning to keep the inner seal as I have no leaks. Is...

Just saw this under the car. Speedo cable is leaking trans oil, the oil is leaking out where the metal is crimped around the cable. Should there be oil reaching the speedo cable? A bit stumped as the cable is brand new, the inner seal in the speedo gear housing is brand new (Installed with the...

Im going to remove a cylinder head to drill out some broken exhaust bolts. What gasket is recommended when putting the head back? And any tips on getting the block/cylinder head surfaces clean and smooth again? (I wont pull the engine, so no milling etc.) 413 block. Thanks