Search results for query: *

Hello I am installing 11.75 rotors on my 66 Charger using the slider type calipers. I could not find any junk yard donors for the brackets so I bought a new manufactured set. Installing my calipers the right side barley rested on the slide, but with future pad wear, it will get better. The...

Can anyone give a good reason for me to keep the old drum spindles and the drums them selves, from 66 and 69 chargers ? Swapped over to front disks with the E body spindles,and I can not think there is a need for drum spindles out there ? Maybe keep one set of drums from future replacement of...

Hello What are the Timken inner and outer bearing numbers for the 11.75" rotors used on the drum to disk swap ? A17 the inner/bigger bearing ? Then the smaller/outer bearing is A16? Found a old receipt that had these along with brake pads sooooo ? Thanks in advance

Hello 66 charger had power brakes, putting in manual with discs up front. I have a 69 charger with manual brakes that I upgraded to discs with same componnets. Please see attached picture. I assume the linkage the pencil points too gets tossed into the spare parts bucket, then my new adjustable...

So, I am rebuilding a 66 charger and going to add front disc brakes. I am going to have to move and would like to finish the front disc brakes and block off/ cap the rear brake line after the proportioning valve, and use the fronts only for getting it on and off a trailer and into storage. Is...

Hello My 66 charger had the single circuit power brakes with drums all around, I am swapping it all out and going with manual brakes using the Mopar Action disc brake swap, I did this with my 69, am very happy, but it was a manual brake car. I see where the 66 power booster has the studs...

Ok, No nightmares but a lot of what the ---- to do. 1966 Dodge Charger, I am going to put disc brakes up front. Did the Mopar Action disc brake swap on my 69 Charger, great, easy. No donor spindles in my area, E Bay ect, are crazy prices with no guarantee they are what they say they are ect ect...

Happy New Year 66 Dodge Charger 318 automatic 318 has been tossed, 383 and 400 in garage waiting for the decission. Question, will the torsion bars from the 318 be adequate with the added weight of a big block ? This will be a street cruising car and will see less than 300 miles a year. Thanks

1966 Dodge Charger Moog front end rebuild kit. Strut rod bushings - there was no new sleeves in the box with the bushings. None in kit. Looked around online, can't find anyone selling these ? Not even in the rebuild kit pictures, but I see energy suspension shows them with their poly bushings ...

Hello, 66 Dodge Charger power steering unit. I see some rebuild/reseal kits out there, has anyone attempted this, and what were your results, good or bad ? Thanks in advance.

Hi, Was wondering, my 69 Charger's rear drum brakes have always had the manual star adjuster. Can you, and or do they make the self adjusters "the cable, arm, and half moon slide" to install in the rear drums ? Thanks in advance !

Hi, Just finishing the front disc brake conversion on my 69 Charger. I have the adjustable proportioning valve installed and set at midway to start out the testing. What, if any, is the average "final" setting ? 1 full turn past midway towards decrease or 1/2 turn towards increase ect ect,? Just...

Hi, I need to replace my manual master cylinder in my 69 charger. The old one was replaced 20 years ago, and the exterior is a total ball of rust/corrosion. Is there any type of paint or product, that I could spray it with, or apply to it, to prevent this ? I will be using dot3 fluid, which I...