Search results for query: *

I'm looking for guidance on how far to tap in some new oil seals. I have new rotors, Timken races & bearings pressed in all the way, but I'm not sure how far in to tap the new seals. I found with an old seal that it could be tapped in much deeper than in these pics, even so deep that the inner...

I've researched that it's recommended to replace bearings and races together, and they're usually sold together. I bought Timken inner and outer bearings for my '70 Charger with front disk brakes. My old inside bearings drop right into the new rotors exactly the same was as the old rotors. Do...

I'm sure this has been asked before, but my searches in this section for "rotor notch" or "divot" or just "notch" turned up nothing relevant. What are these notches for? Online searching seems to show a different kind of notch is machined along edges of rotors to balance them, but both my old...

So I bought the Moog K7103 offset bushings to get more caster when my car is ready for an alignment. I will also need to remove my UCA's to install new UCA bump stops as mine look like squashed grapes. I was able to remove the old bumpers, but jacking up from the control arms, they don't lift up...

I have to remove my '70 Charger's disk brake backing plates and saw there's a foam gasket there. I can't seem to find replacements on RockAuto and I don't think my old ones are salvageable. Where can I get new ones, or is there a suggestion for alternatives?

I was under the front end to double-check the routing of my new fuel lines and checked the steering components for play. Everything was tight except for the Pitman arm link. I noticed right away something was amiss because there were no cotter pins on the castle nuts for the Pitman arm and link...

I'm interested to know some recommendations for upgrading from the stock front suspension & steering components, with emphasis on best bang-for-the-buck; i.e. most noticeable improvements for your dollar. Clearly there are guys with large bank accounts that can do full-on resto-mods and...

My master cylinder started leaking a few months ago where it bolts to the booster, below the lower 2 bolt holes. Upon removal, I found it's the desireable Bendix unit, so I want to have it rebuilt. The P/N on the bottom shows '22268' but not sure what the last 2 digits are; possibly '24' or...

I put in an order for some front shocks for my '70 Charger on RockAuto.com. I chose Sachs #030 816 as those have been reviewed as very good for the price and the parent manufacturer is German. These are to replace some KYB Gas-A-Just shocks that many reviews state are too stiff. Anyway, RockAuto...

I got a paint gasket kit for a 1970 Charger that included these 3 gaskets for the master cylinder to brake booster. Unfortunately there's no mention of how they should be installed. My master cylinder is leaking where it bolts to the booster. The 3 gaskets include a grey paper gasket and 2 foam...