Search results for query: *

Tracking down cause for a no spark condition. So, since I'm not a auto electrical guy, I'm learning as I go. I've checked for voltage at the ECU, the Ballast resistor, and the coil + side. I get 12 (plus) vdc at the ECU connector, the Ballast resistor, and almost 12vdc at the coil until I...

Anyone ever have a pick up coil in a MSD distro go bad on them? I'm in the process of of tracking down the cause of a no spark condition, and just read about some folks having issues with the MSD coils? The distro was bought a few years ago (new), installed last year and the motor fired at the...

I'm running an MSD distributor on my car, 66 coronet, early 70's 400 (408), with early 70's ign/charging setup. Running an aftermarket 4 pin ign cntr mod. To the best of my research abilities I traced out the + and - dist leads from the module, the leads from the distributor are known from MSD...

Wondering if someone can answer this question for me, I searched and couldn't find a previous thread that did. I'm setting up the ignition on my car 66 coronet, using and electronic system. I have an accel super coil installed and have added the additional ballast resistor that they say must...

This has probably been asked before, and I'm not an electronic ignition guy however I must ask a question. I have a performance ignition system for my coronet that's good up to 7500 rpm. The system is designed to work with a vac-advance electronic distributor. It's not a mopar unit but the...