Search results for query: *

I noticed while installing this today. I have a new Msd box going to an older msd distributor and of course the tech support is closed on a saturday. Im not sure how to wire the weather pack connector im making. I know the 6al box wires to the distributor are, Green/+ and Violet/-, but on the...

When centering these rockers over valve tip I was advised it is not necessary to use the .015 or .030 steel shims, if alignment was good. That would mean the aluminum body of the rocker would ride on the aluminum spacer required to get the correct offset. Will that be acceptable when you have...

Is there a "rule of thumb" to go by as to what SHOULD be, in THERORY, the leanest cylinder on a 440 mopar? The combination in question is a 540" with crossram intake. I will be putting it on an engine run stand next week and have an extra EGT probe and gauge sitting around, so I was going to...

When installing any system such as this you need to plug the original hole inside the block where the stock pickup was located. Is there any reason I CANT use a brass plug that I was able to find with the correct thread or would it have to be a steel plug? I'm probably over thinking this but Ive...

The block is a stroked 440, and I'm running a Milodon 7 quart, plus filter, "30930" pan with a 1/4" thick main bearing girdle. I'm trying to figure out how to determine where the perfect oil level is and mark it on the dip stick. The motor is 100% apart and on the stand. I'm sure there a correct...