Search results for query: *

1968 383 block and the rear cam plug is missing. Can anyone give me the specs, part number or any way to find one so I can fill it up properly?

I have seen dual Fender tags with one item on them. Was there ever multiple items like Hemi Engine and Special Paint on the same tag?

426 Hemi Dipstick Tube Sheathing. I am looking for a supplier for just the white sheathing. I nee about a foot of it.

I have been searching for a spot welder to finish installing some panels. The Harbor Freight is cheap and breaks a lot. It also has too fine of a point at the weld. I have considered flattening out the tips a bit to give a 5/16 inch spot weld. I am only going to use this for this one project...

I am having trouble getting my back glass to adjust. The brace in the lower left of the picture is the way I installed the parts but it looks like to get the tilt I need the bracket is in backwards. Does anyone have a convertible with that bracket installed that can give me a definite orientation?

My spare came in today for my 69 RR Convertible and the label on the trunk lid is a little vague on how it mounts. If shows two wingnuts, like one clamps the hook to the floor first. Can't tell if the spare is up or down. Checked the parts book, service manual and owners manual. No luck! Does...

Who offers an auto trans backup light and safety switch harness that has the correct plug for round pins? I bought all my harnesses from Evans but they are using the wrong terminals at the switch. Original plugs Evans plug

I am installing the front seal and don't know which side is out. Does anyone know?

I guess this would be considered Tech. I have a car that I listed on Craigs List and a person from Pennsylvania called me and wants to buy the car and arrange to have it shipped to him from Florida. He offered to do any of the following; Wire, Overnight, Bank Transfer, Cashiers check. With all...

Page 54. 68 Charger loaded with options, including a very rare electric hood and trunk release system! Do you think using one of them for a hood release will be practical with water coming through the grill? I have a spare electric release and thought it is an interesting idea for my...

I was looking at the metal Air Grabber Air Cleaners from Northwest Performance/ Shakerhood.com. for a 69 383 RR. I have done the Voice Mail, E-Mail, and trying calling many times over the past weeks without any luck. I normally accept that if someone is that hard to reach before you buy then...

Installing a 5.7 and we found a used hose that will work but don't know the original application. Most likely off an older Mopar. Lower hose with 1-3/4" ends (although 2" at the pump will be better) Passenger side. It needs to go over the oil filter just like the drivers side ones does on...

I am working on a factory a/c system on a 69 Road Runner. In my box of parts there are two aluminum and two plastic sets of side dash vents. When were the aluminum ones used and when were the plastic ones used? There are also plastic center vents with an aluminum bezel that attaches next to the...