Search results for query: *

This afternoon my buddy is going to help me figure out what is going on with my 62’ Fury - 361/4. I’ve had recent carpal tunnel surgery on both hands so can’t do much myself. Saturday I had it out for my first cruise this year. It started and ran very well 11-12 miles into town for the cruise...

Duplicate

When did Ma Mopar begin phasing out these twisted wire clamps (upper clamp) on the Bbodies? I’d love to get rid of mine on the fuel and coolant lines but also want stay “correct”…

Ok, I have to post this. If you are even thinking of buying one of those fake battery toppers to make your battery look old - don’t! They are ridiculously cheap made for something that sells for $60. They are made of real thin gage stamped plastic - about like the stamped plastic treys that...

Wasn’t someone here selling tie down plates that bolted up under the rear leaf spring perches? Any leads ?

Have a dumb but honest question. Just picked up a set of valve cover gaskets for my 361 and with it came four round mini gaskets - I assume for the 4 studs. Are these an original feature of the early BB gaskets and if so how are they supposed to be installed? Wouldn’t think you’d want them on...

Ok, I ran across something I’ve never encountered - or heard about before. Looking at a car with a 440 in it. PO tells me he had a problem with it “blowing plugs” initially. By blowing he says that a couple times it blew the centers out of the plug, electrode and porcelain??? Not sure if it was...

I know this was discussed before but i'll be darned if I can find the thread. What's involved involved in changing the speedometer gear in a post 66' 727? If i recall there was some allignment issue to watch for? My new gear has black marked on one tooth. Does that need to go in at a certain point?

Sometime back there was a fellow selling some nylon bushings that fit around the steering shaft and up inside of the column tube on the engine end. They were held in with one or two small screws. I think he was from NC someplace. Anyone know where to get these?

Looking for some input. Seems my Holley HP 150 bit the dust yesterday and I need a new fuel pump. Current set up is the HP-150 going to a Holley regulator with a split feed to each front and back bowels on a Holley HP 950 carb. The car is driven mostly on the street these days to and from...

Anyone Know a Dana 60 Shop in NC? Anyone know of a good place in NC or SC that can set up a Dana 60 for me and maybe do some suspension work? I want to replace my spool and 4:56 gears set and I will need to have a differental and new gear set installed - properly. Most likely going to use a...

Anyone know if the gage cluster panel from the 63' Plymouth B - body (Savoy, Belvedere, SF) will fit the 62' ? I know the gage layout is different and all, I'm just trying to determine if the outside shape and mounting screw holes are the same. They look the same but just wanting to be sure they...

Always assumed that the Dana under my car was an actual Dana manufacture. Tonight as I was looking it over I noticed that there were no numbers on the axle tube. I got looking through my references and from what I understand all Dana 60 housings - made by Dana, had a date code and a bill of...

Had something strange happen today with my 62' Plymouth - after doing something a bit "strange" with it Our local car club had a small show this morning at the Rockingham Speedway just before the start of the Polar Bear 150. Our club along with a group of old vintage stock cars opened the race...