Search results for query: *

Hey guys, Been awhile since Ive been here. Got rid of my 69 Coronet project about 3 years ago. I dont really regret it, but now I want to get back into another B body. Found a 70 Sport Satellite locally. Going to take a look saturday. Seller is the 2nd owner and has had it since 1983. 318...

Hey all, Have my doors off and want to tear down for strip and repaint. Was wondering what is the best way to go about this? So far all I have off is the window roller, side mirror, handle, and trim panel. Need to get out the glass and "guts". Actually, do I need to take everything out...

Grandpa farts? Ok, but seriously, I dropped my tank on the project. Last filled up over 2 years ago. Probly still about 3-4 gallons in there. What do I do with it? Could I just add a little to my DD every time I fill up? Like 15/1 new to old ratio? I dont want to waste it...gas aint...

Do I get the rear seat out of my 69? I see no bolts going thru the floor like the front and I cant see or reach under the seat to see if any clips or keeper. Stumped on this one....

Anyone know how much a complete 8 3/4 weighs minus the brakes?

Hey all, I removed my column for a couple reasons. One, Im going to convert to SCS cheetah floor shifter, so I either need to replace the column shift collar with a floor or manual one or cut it off, grind, sand, etc. to make it look nice. Two, Im going with a power to manual steering...

Hey all, So my car wont be done for at least a year. In the meantime I store the engine, tranny, and axle in the garage. I oil the cylinder walls and turn over the engine by hand every other week, but how should I store the tranny and axle? Tranny has fluid in it, but can I just let...

Hey all, Wondering if anyone is running a 3200-3600 stall TC in their street cars. 69 Bee, 451 stroker, six pack, 727 rev manual, 275/60/15's. Currently has 8 3/4 w/ 3.23's, but Im looking at getting a new pumpkin with 4.10's. Also cam is relatively mild, chosen based on the...

Have the rear axle off the car as part of teardown. What can I do with it while its out? I figured at the very least, remove center section for inspection and change fluid. Do you guys suggest pulling the axle shafts and rebuilding with new bearings, seals, etc since its out or just...

Hey guys, Working on my teardown and ran into a couple problems. 1) Any advice for rear leaf spring shackle removal? I can get lower nut, but the upper can can only be reached with an open end. The front is off, all I need to do is that one rear upper shackle/nut. 2) Feel kinda dumb...

Hey all, I have a 65 727 with the 19 spline input shaft and 27 spline shaft support. I got a barely used 2800 stall TC from a buddy for next to nothing, but its made for the 67-up as its got 24 spline count. When I pull the stock TC off of the tranny and count the splines on the...

Hey all, Ive tried to lube em and torch em...I hit em with the breaker bar and impact. Nothing...wont budge. Anyone see any problems with me just cutting them off? What would be the best and easiest way? Ive never had to cut off a stuck bolt or nut before...so Im not sure what to use...