Search results for query: *

So on the Hellcrate setup into a 69 Charger with an Aeromotive Stealth fuel tank. The first expert I asked, very strongly recommended a conventional fuel pump, regulator and return line setup. But then I spoke to tech support at Aeromotive and they said their tank and pump were designed...

So I’m starting to get the wiring harness for the engine, transmission and body harness sorted out. I ran across a weird one on the CBID as Mopar calls it which receives the speed signal from the transmission and inputs it to the CAN bus. The Dakota Digital speedometer picks it up from there...

I've searched the forum and the internet but as usual its a "drink from a firehose". I'm rounding up parts for a trunk mounted battery and I can't resolve the logical circuit breaker size. The Hellcrate instructions call for a max 200-amp battery. Is 200-amp the suitable circuit breaker...

I got the Rear big stuff installed and thought I’d share a few pics. Got my driveshaft measurement and placed that order with Drive Shaft shop. Ordered the driveshaft loop from USCT. Next comes final welding and then paint. I need to setup the welder to put argon inside the frame rail for...

So I’m working through issues from the first mock-up up the Hellcrate into the 69 Charger. Overall I think the fit is pretty good. The Steering column worked out well. Lots of room for brakes. The ECM placement becomes pretty obvious behind the vintage air box. Of course the dodge wiring harness...

Landed the crossmember today with the Hellcrate and T-56 Magnum, headers and all auxiliaries. Motor install from below is the way to go if you have a lift! Positioned the USCT trans crossmember supports. Tomorrow should be a welding day. Only issues at this point seem to be the wiper motor and...

Hey guys, I’m prepping a Hellcrate motor for installation into a 69 Charger. Starting to layout the wiring harness and had a couple questions: If the ECM is installed behind the dash, what size firewall penetration is needed and how would it be closed around the wiring harness or is it best to...