Search results for query: *

Does anybody have experience with a QA1 rear suspension for a 68-70's b body? Will 3 inch exhaust pipes fit?

I've got a P0688 code on the tuner with my Mopar Crate Harness Kit 6.4 Hemi. Car ran great before. I've checked the relays and fuses, the battery and ground cables are good. Can anybody help me out?

I'm in the progress of getting the final things done before driving my 70's Satellite. It has a 2014 6.4 Hemi engine, a 2006 NAG1 transmission and I'm using the Mopar Harness kit with the Sound German Automotive kit. I've connected the canbus wiring (canbus high and low) from the SGA kit to the...

I've swapped a NAG1 behind the 6.4 Hemi in my 70's Satellite and was woundering what you guys are using for a driveshaft? A one piece or a two piece driveshaft? I'm still using the 8 3/4 rear end with 489 carrier. I'm measuring almost 64 inches between the Sonnax trans yoke and the u bolt yoke...

Is there a way to install automatic wipers like in modern cars?

When doing a custom dash I would like to have a fuel light besides the fuel gauge that turns on at a certain fuel level in the tank. My electrical skills don't go that far but is it possible to make? Is it an Ohm thing?

How much fuel flow does a 6.4l stock Hemi needs? I've bought a Spectra tank, model CR9CFI with an intank fuel pump (through Rockauto.com) and it states that the pump has a flow rate of 68 gph -77 gph and a pressure of 55-85 psi. The Hemi needs 58.5 psi, so that's covered. Also where did you...

What tuner do you guys use when using a Mopar harness crate kit?

Has anybody ever used this kit? How can the tach signal be picked up for a tachometer?

I’m in the process of installing an a518 46rh behind my 2013 6.4 Hemi into my 70’s Satellite and have to make a bracket for the transmission. I’ve used TTI bracket styl motor mounts with stock insulators. The engine and trans were installed into the car but I found out that the trans hit the...

Post them modern seat you've put in your ride. We would love to see them!

I was thinking would it possible to use a Face ID or pin code as an anti theft system to start your car? Has somebody been down this road?

Does anybody have a wiring diagram to share for2008/2009 SRT seats in an-body? The driver seat is electronic adjustable 3 ways, has heating and a seatbelt wiring. The passenger seat has heating and a seatbelt wiring.

I have a 2013 6.4/392 SRT8 out of a automatic Grand Cherokee which I would like to convert to NON MDS because of all the story when not using the MDS in a swap cause engine failure. This has to do with the valve lifters and not getting oil when MDS is activated, so I was told. Does anybody...

Who can tell me how much higher the tunnel must be to fit a NAG1 behind a 2013 6.4/392 in a 70's Plymouth Satellite? Does the tunnel have to be wider?

Wanted to make this topic for tech info of swapping to the NAG1 or 8HP70 transmission. Which tuner/stand alone setup did you use? How much did you modify the trans tunnel (with some pictures, please)? Cross member modifications? Which driveshaft options are there? Which shifter kit did you use...

Does anyone know Sykedecutuning.com? I'm looking for software to reflash the stock PCM that came of a 2013 Dodge Charger SRT8 to make my 2013 Jeep Grand Cherokee SRT8 run. Looks like affordable software.

I have a 2013 6.4 Hemi SRT8 and an a518 46RH TF which i would like to use for a swap in my 70's Plymouth Satellite. Is there a way to use the Drive by wire and how is it possible to make the kick down linkage work?

I have a 2013 6.4l Hemi SRT8 out of a Jeep GC and an engine harness with PCM, gas and brake pedal from a 2013 Dodge Charger 6.4l Hemi SRT8. Is there a way to make the engine run with these parts? By perhaps reprogramming the PCM?

Looking for inspiration, let's see those custom dashes and consoles! Thanks!