Search results for query: *

1967 Coronet 318 car swapped with many upgrades 426 Hemi Mopar block using schumacher Spool mounts. 1. Front ears of K member bolt up no issue to k member. Back two ears will not get closer to frame then 3/4 of an inch. Ive looked every where for possible hang up. Nothing is interfering. If i...

I have apair of wing window frame fully restored and replated. 325.00 each and a pair of grill surrounds that need restoration and both are left sides only left sides. 375.00 each

Looking for help where the supports mount inside dash any help appriciated

The inner column has plastic pieces i beleive are guides or some kind of break away part. I want to remove them safely if i can in order to send out column for powder coating. Anyone identify what they are and proper way to remove? I can hve my son reproduce using a computer printer if i need...

Looking if any one has plans to add hydraulic cylinders to trunk lid on 67 coronet to assist torsion bars don’t need expensive aluminum brackets

Looking for input after glass was installed a small void exists between gasket and body on 67 ht coronet. I’d like to add some bedding compound to reduce this area for dirt and water and fine some kind of tiny tip for bottom any help appreciated, stainless trim will cover the edge of course

Looking for input here I have side covers for 67 rt coronet bucket seat car each side of bucket has metal side cover I believe outer facing door is bigger than the one facing center console tell me your thoughts Also metal seat backs have a plastic fabric tried hot tanking to remove and media...

Looking for any help tried what I know and reading fan is a bit confusing with vague terminology

If anyone can tell me how deep into Vent window base frame the glass should go in id appreciate. The chrome support piece has two ledges that appears to only let you set glass into the setting tape 1/8 of an inch

Any one know what fasteners where used on the edge of front fenders to hold the large aluminum head light surrounds. Their 3 holes vertical that are 3/8 in diameter. i remeber 30 years ago taking a long 1/4 rachet with long extension and unthreading but my memory after that is vague.

Can anyone tell me how these three bushings get used on wiper motor please

Looking for ideas about locating the swing out bar on roll cage for 67 Coronet. I want to keep arm rest intact and use window role up. I plan on installing a piece of 2x3 in front of front torque box under floor with a 6 inch piece of 1 5/8 coming out of floor. I am looking to keep door opener...

Looking for help with the transmission linkage for center console shifter. I am putting on a set of tti headers on the Motor and the linkage shaft needs modification on this 67 coronet. Anyone do this before? Any help appreciated. I cut the support plate and overlapped like TTI says but I am...

Can anyone tell me the part number for seat tracks on a 1967 Dodge Coronet Bucket seat car. My seat tracks are badly rotted out and since i replaced the floor pan I would like to search for newer tracks and need to know what these cross over too. Regards, Steve

Rebuilding the lower plenum on my 1967 Dodge Coronet. Any one have experience doing this. Since im replacing the top plenum cover wanted to see if anyone has an idea how to improve this area from debris, leaves and dirt that gets wet and rots thru the area past the air horn

Hello everyone I thought I would send in a few pics of a project I am working on. This car has been sitting 25 years finally i decided to finish it since the kids are almost thru college. The body had a great deal of rust repair and it was a weekend labor of love. I figure 1 year and it should...