cudak888
Well-Known Member
Just pulled these off my 8-3/4" rear end - I upgraded to 11's.
Hardware is newer than it looks; was replaced a few years ago by the PO (note - the drum actuating pins that sit at each end of the cylinder are really rusty, as I swapped these when I upgraded). Backing plates are really nice on the inside; rears have that factory sound deadener/undercoating on the backside.
Pads are used, but have meat left on them, right side is slightly gacked from the drum sitting too far inboard (I've got a thrust block issue in my differential). Would be wise to radius the pads and have the drums machined before use.
See photos.
$100 + $16 per drum assembly for shipping (each in its own Priority Medium Flat Rate Box). PayPal only. Or pick up and save on shipping in Miami, Florida.
-Kurt
Hardware is newer than it looks; was replaced a few years ago by the PO (note - the drum actuating pins that sit at each end of the cylinder are really rusty, as I swapped these when I upgraded). Backing plates are really nice on the inside; rears have that factory sound deadener/undercoating on the backside.
Pads are used, but have meat left on them, right side is slightly gacked from the drum sitting too far inboard (I've got a thrust block issue in my differential). Would be wise to radius the pads and have the drums machined before use.
See photos.
$100 + $16 per drum assembly for shipping (each in its own Priority Medium Flat Rate Box). PayPal only. Or pick up and save on shipping in Miami, Florida.
-Kurt
