SOLD 18 spline hemi 4 speed

[pnypwr]

Have a 18 spline I’m looking to sell to fund some work on my house. It’s a b body unit I had a dual pad tail housing put on. It has a billit bearing retainer. It was in my car and worked good but did grind a bit going into fourth quickly. I was going to have it gone through but plans changed. 1550 picked up in eastern ct. can ship but will be expensive

 

[Fran Blacker]

Any VIN? Looking for one, last 4 digits 5353.

 

[pnypwr]

No vin

 

[Fran Blacker]

Thanks

 

[Jessejames]

Delete your messages please. You inbox is full

 

[pnypwr]

Ok cleared out

 

[pnypwr]

Here’s the pad be amazed it says nothing

 

[Dragon Slayer]

Looks like an early small bearing housing, so someone may have transfered parts, hence no vin.

 

[AR67GTX]

The 372 case is a 307 bearing case late 1966 - 1967. The cast surface, blank ID pad is typical of them In 1967. The only tail housing I found with the dual shifter mounts is C99621 for some 70 B- Body cars andit used the the 308 bearing. That doesn’t seem to be the casting number on the transmission above however.

 

[Dragon Slayer]

Truck OD tail housing used it also.